MXDM70 INSTALLATION
Preparation
Please read entire manual before installation.
Before You Start
•Disconnect negative battery terminal. (consult a qualified technician for instructions)
•Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.
Getting Started
•Remove 2 transit screws located on top of the unit. Cover transit screw holes using the supplied adhesive dot labels.
•Insert the supplied keys into the slots
as shown, and slide the unit out of the 
mounting sleeve.
• Install mounting sleeve into opening, bending tabs to secure.
• Connect wiring harness and antenna. (consult a qualified technician if you are unsure)
• Test for correct operation and slide into mounting sleeve to secure.
•Snap trim ring into place.
•Mount the iplug™ adapter to any smooth clean surface using the supplied
head screws.
TYPICAL
2