Standard Horizon GX1250S owner manual Installation Using Regular Mounting Bracket

4.3 INSTALLATION USING REGULAR MOUNTING

BRACKET

1.Mount the bracket using the washers, nuts, and long hex head bolts.

2.Thread the mylar washers onto the mounting bracket knobs.

3.Position the transceiver within the bracket arms, matching the transceiver notches to obtain the desired positioning.

4.Secure the transceiver to the brackets with the mounting knobs (see Figure 4).

5.Connect the antenna and power cables (and optional speaker) to the transceiver.

4.4 INSTALLATION USING CMB16 FLUSH MOUNT

BRACKET (Optional)

Refer to Figure 5 for the following procedure.

1.Use the template supplied with the CMB16 to mark the location (inner template) where the rectangular hole (5-5/16 by 2-1/16 inches) is to be made. Confirm the space behind the dash or panel is deep enough to accommodate the transceiver. There should be at least 1/2 inch between the transceiver’s heatsink (fins) and any wiring, cables or structures.

2.Cut out the rectangular hole and insert the transceiver.

3.Fasten the brackets to the sides of the transceiver with the lock washer nut combination, so the mounting screw base faces the mounting surface (see Figure 5).

4.Turn the adjusting screws to adjust the tension so the transceiver is against the mounting surface.

Page 10 Owner's Manual GX1250S