Table of Contents |
| |
Intel® Server Board SE7500CW2 Troubleshooting | 4 | |
Boot Issues | 5 | |
1) | My server will not power on | 5 |
2) | My hard disk drive (HDD) lights went on, I heard the drives spin up, and my |
|
floppy drive light turned on, but I’m not seeing video | 6 | |
3) | I am installing adapters in my |
|
up when I install a PCI adapter | 6 | |
4) | Some of my hard drives show up during POST and some don’t | 7 |
Other Questions | 8 | |
General Questions | 8 | |
1)Is it possible to enable
server board? | 8 | |
2) | What order must I populate processor sockets? | 8 |
3) | How do I disable | 8 |
4) | Do I need a processor terminator for Intel® Xeon ™ processors on SE7500CW2? | 8 |
5) | How do I ensure redundancy across Promise ATA 100 RAID controllers? | 8 |
6) | How do I get Microsoft* Windows NT 4.0 to install? | 9 |
7) | How can I enable Direct Memory Access (DMA) under Red Hat Linux 7.2 or 7.3? .... | 11 |
8) | How do I get NetWare 6.0 to successfully install? | 12 |
Memory Questions | 12 | |
1) | What memory configurations are supported on the SE7500CW2? | 12 |
2)What kind of problems might occur in an
DIMMs? | 12 |
Jumpers and BIOS Setup Options | 13 |
1) How should the jumpers be set on Intel Server Board SE7500CW2? | 13 |
Input/Output | 13 |
1)Does the Intel® Server Board SE7500CW2 support Ultra ATA/33/66/100 hard drives?13
Intel® Server Board SE7500CW2 Issue Report Form | 14 |
SE7500CW2 Troubleshooting Guide | - 3 - | 08/21/02 |