Grizzly instruction sheet Model H7528, Resaw Fence for, G0531/G0566/G0568/G0569

MODEL H7528

RESAW FENCE FOR

G0531/G0566/G0568/G0569

INSTRUCTION SHEET

Introduction

The Model H7528 Resaw Fence upgrades the	�
standard fence that came with the G0566/G0568.
Installing the resaw fence on your old fence
requires that you drill a hole in your old fence.

Inventory (Figure 1)			�
A.	Resaw Fence	1
B.	Adjustment Handle	1	�	�
C.	Flat Washer 8mm	1
D.	Moving Plate	1
Drilling the Hole			Figure 1. Model H7528 inventory.

Before starting, you should have a pencil, a mea- suring tape, a center punch, a hammer, a 3/8" drill bit, and access to a drill press (a hand drill will also work, but results may vary).

To drill the hole in your fence:			�������������
1. Measure the center-point of the hole (see		��
Figure 2) and pencil it in on the face of the
fence.	�����������������������

2.Use the center punch and hammer to indent the center-point on your penciled mark.

3. Observe all safety precautions given for your drilling method (refer to your Owner's Manual), and drill the hole completely through your fence.

Assembling Fence

Figure 2. Diagram for drilling the hole.

1.Insert the adjustment handle with washer through the hole in the fence and attach the

moving plate on the other side of the fence (Figure 3).

2. Slide the resaw fence over the moving plate,	Moving Plate
center it with your original fence, and lock it
in position with the adjustment handle.
	Figure 3. Installing resaw fence.

3.Mount the fence assembly on the bandsaw.