Lowrance electronic X50 DS manual Trolling Motor Bracket Installation

Page 16

Trolling Motor Bracket Installation

1.Attach the optional TMB-S bracket to the transducer as shown in the following figure, using the hardware supplied with the transducer. (Note: The internal tooth washer is supplied with the TMB-S.)

TMB-S bracket

Internal tooth washer

BoltNut

Flat washer

Attach motor mounting bracket to transducer.

2.Slide the adjustable strap supplied with the TMB-S through the slot in the transducer bracket and wrap it around the trolling motor.

Position the transducer to aim straight down when the motor is in the water. Tighten the strap securely.

3.Route the transducer cable alongside the trolling motor shaft. Use plastic ties (not included) to attach the transducer cable to the trolling motor shaft. Make sure there is enough slack in the cable for the motor to turn freely. Route the cable to the sonar unit and the transducer is ready for use.

Transducer mounted on trolling motor, side view.

12

Image 16

Contents Fish-Finding Sonar Copyright 2006 Lowrance Electronics, Inc All rights reserved Visit our web siteTable of Contents Troubleshooting Capabilities and Specifications X50 DS GeneralBack-up memory SonarHow Sonar Works Sonar soundingAutomatic ranging Zoom bottom trackDual Search Transducer PreparationsInstallation Recommended Tools and suppliesSelecting a Transducer Location How low should you go? Transom Transducer Assembly and Mounting Shoot-Thru-Hull vs. Transom MountingAlign plastic ratchets in bracket Assemble transducer and bracket Transom Bottom Hull Flat-bottom hullDeep-vee hull Trolling Motor Bracket Installation Transducer Orientation and Fish Arches Shoot-Thru-Hull PreparationEpoxy the transducer to a solid portion of the hull Testing Determines Best Location Shoot-Thru-Hull Installation Power Connections permanent mount only Mounting the Sonar Unit In-Dash, Bracket or Portable Bracket Installation Using the Quick Release Mounting Bracket Portable Sonar Installation Installing the Batteries Mounting the UnitRatchet Tie Nylon Cord here Suction Portable Transducer Storage Page Operation Keyboard BasicsMenus MemoryUP & Down Arrows ↑ ↓ Full Chart DisplayDepth Range Zoom Sensitivity To adjust sensitivity in Auto Mode To adjust sensitivity in Manual ModeGrayline Chart Speed Frequency Fish I.D.Fish arches Fish I.D. symbols Fish Alarm AlarmsFishTrack Depth Alarms Shallow AlarmDeep Alarm Battery AlarmNoise Rejection and ASP Noise Rejection menu Temperature Display To display TemperatureDepth Display To display DepthTo display battery voltage VoltageBacklight ContrastReset Options Set LanguageSoftware Information To select a languageUnit wont turn on Unit turns on only in simulator modeUnit freezes, locks up, or operates erratically No fish arches when the Fish I.D. feature is off NoisePage Lowrance Electronics How to Obtain Service… Not toll-freeAccessory Ordering Information for all countries Visit our web site