Lowrance electronic 100 installation instructions Display unit

Page 18

LRA-4000, LRA-5000 open array radars

See following detail drawing C

RIM 100 SP

Dark gray (not used)

Display unit

Purple/Transmit

White/Receive

Drain/Ground

Data cable for future serial device.

RIM power/data cable

Display unit power/data cable

RIM Data

Display unit

Display unit pwr

data

 

RIM Power **

 

 

(red/power +;

 

NMEA 2000

black/ground –)

 

network pwr

 

See following

 

 

detail drawing D

 

Cable connections and wiring diagrams for Lowrance radar, RIM 100 interface module and display unit. These connections cover models LRA-4000, LRA-5000 open array radars.

† Serial device data cable may need RIM software update to use.

**Note: RIM power cable must be connected to the same 12-volt power source as the radar's display unit.

14

Image 18
Contents Radar & RIM Copyright 2006 Lowrance Electronics, Inc All rights reserved Table of Contents Page Introduction AntennaSide lobe Targets difficult to display on screenRadar Shadow Zones False echoes Radar interference LocationObtaining sufficient dip angle Mounting BasePage Page Radar Installation Page RIM 100sp Installation RIM 100 RS-232 Power/Data Cable Cable Connections and Wiring Diagrams Detail Drawing a Display unit Detail Drawing C Lowrance Radar Specifications FCC Compliance Page Page Page Lowrance Electronics Full ONE-YEAR Warranty How to Obtain Service… Not toll-freeAccessory Ordering Information for all countries Visit our web site