Important SAFETY
Information
Use caution when open- ing the plastic case; risk of electric shock.
Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and re- frigerator enclosures during instal- lation.
WARNING! All connections MUST be done with the Inverter’s Power Switch off.
Connect all wires securely and cover the connections with insulat- ing rubber boots (not included). Store metal objects away from the inverter.
Assembly Instructions
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
Set up and Use Precautions
1.Set up only according to these in- structions. Improper set up can cre- ate hazards.
2.Wear
3.Keep area clean and well lit.
4.Do not set up when tired or when under the influence of drugs or medi- cation.
5.This product is not a toy. Do not al- low children to play with or near this item.
6.Use as intended only.
7.Inspect before every use; do not use if parts are loose or damaged.
8.Maintain product labels and name- plates. These carry important safety information. If unreadable or miss- ing, contact Harbor Freight Tools for a replacement.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Caution: This inverter must only be con- nected to batteries with a nominal output voltage of 12 volts. Lower voltage will not operate the inverter properly, and more voltage could damage the inverter or the device being powered. If more than one 12 volt battery is to be used, the batter- ies must be connected in a parallel circuit; batteries connected in a series circuit will produce too much voltage.
1.Place the Power Inverter on a flat surface. Make sure it has adequate ventilation and is not in direct sun- light. Locate the Inverter close enough to the battery so that the cables can easily reach between the Inverter and the battery. Position the Inverter so that the Outlets are easily and safely accessible. Make sure the Inverter is in its OFF position.
2.Using an 8AWG or larger ground- ing wire (not included), connect the Grounding Terminal to a ground-
SKU 66835 | For technical questions, please call | Page 5 |