Invacare 9669 Adjusting the Leg Height, Installing/Removing the Commode Seat and Lid

Adjusting the Leg Height

NOTE: For this procedure, refer to FIGURE 1.

1.Remove commode from carton.

2.Align the snap button of each leg extension with the appropriate adjustment hole in the leg frame.

3.Make certain that the snap buttons are fully engaged into the adjustment hole of each leg frame and are at the same height before using.

Leg Frame

Snap Button

FIGURE 1 Adjusting the Leg Height

Installing/Removing the Commode Seat and Lid

NOTE: For this procedure, refer to FIGURE 2.

Installing

1. Align the seat clamps of the toilet seat onto the back frame rail. NOTE: Each clamp should sit outside the pail holders.

2.Push down on seat until it clamps firmly into place.

3.Repeat STEPS 1-2 to install the lid.

Commode Seat (Lid Not Shown)

Removing

NOTE: Always remove the lid before removing the seat.

1.Grasp the back corner of the lid and lift up firmly.

2.Repeat STEP 1 for the seat.

Seat Clamp

Pail

Holder

Pail B ac k Frame Rail

FIGURE 2 Installing/Removing the

Commode Seat and Lid

Operating the Drop Arms

NOTE: For this procedure, refer to FIGURE 3 on page 3.

1.Grasp one arm latch handle firmly. Refer to Detail “A” of FIGURE 3.

2.Squeeze the arm latch handle toward the drop arm tube shown in FIGURE 3.

3.Gently lower the drop arm tube shown in Detail “B” of FIGURE 3.

4.Perform STEPS 1-3 for the opposite arm.

Drop Arm Commode 2 Part No 1062011