Dometic HTS-EC, 1600 Proper Toilet Cleaning and Maintenance, Winterizing Toilet, To drain

Page 7

PROPER TOILET CLEANING AND MAINTENANCE

Dometic china toilets should be cleaned regularly for maximum sanitation and operational efficiency. You can clean it just as you would a household toilet.

Do not use caustic chemicals, such as drain-opening types, as they will damage the seals.

BOWL CLEANING: For stubborn stains, use SeaLand® Bowl and Seal Cleaner (Fig. A). It’s manufactured especially for use with Dometic toilets. In certain locations where water is hard, a build-up of lime may dull the toilet bowl finish. Restore the shine with this SeaLand cleaner. If you cannot find it in your area, contact Dometic for your nearest dealer. If this cleaner is not available, you can also use Bar Keepers Friend® cleanser. It is not necessary to vigorously scrub with either product. Please follow label instructions.

SEAL CLEANING: After an extended time, mineral deposits from hard water can build up under the edge of the rubber bowl seal, resulting in a slow leakdown of water from the bowl. To prevent this mineral build-up, periodically clean under the bowl seal with SeaLand Bowl and Seal Cleaner (Fig. B).

1.Shut off water supply and power to vacuum pump or vacuum generator.

2.Apply cleanser onto a cleaning brush, open the flush ball by pressing on flush lever, and scrub under the seal. Make sure to push brush bristles between bottom of seal and top of flush ball surface to scrub all parts of seal that come into contact with flush ball.

3.Close ball and wait 2-3 minutes.

4.Open flush ball. Use brush and water to rinse away cleanser and loosened deposits.

5.After cleaning, turn on water and electrical power to toilet system.

Fig. A

Fig. B

WINTERIZING – TOILET

At the end of each season, the Dometic toilet should be winterized for storage by either draining or using potable water-safe antifreeze in the system.

To drain:

1.Thoroughly flush system with fresh water.

2.Empty holding tank.

3.Model 1606 only: Shut off water supply to toilet(s), and remove inlet waterline (Fig. C). Do not remove brass cap on bottom of valve.

Model 1609, 1648: Shut off water supply to toilet(s), and remove plastic cap from bottom of brass fitting (Fig. D).

Do not remove brass fitting on bottom of water valve.

4.Press flush lever until all water is drained from toilet(s).

Fig. C

Fig. D

7

Image 7 Contents
Page Features Table of Contents Model Description Size Weight Length x Width x Height Model Numbers and DimensionsVacuum Toilet Generator VacuStat Panel TankWatch Panel KEY System ComponentsSystem START-UP Important Information Before OperationWinterizing Holding Tank Cleaning Holding TankVacuum Toilet Operation Holding Tank Operation DischargeDo not remove brass fitting on bottom of water valve Proper Toilet Cleaning and MaintenanceWinterizing Toilet To drainSpare Parts Maintenance ScheduleService TIP Description Part Number Quantity Where UsedToilet Model Identification Special Toilet Tissue and CleanerModel Troubleshooting GuideProblem Possible Cause Service Instructions Models 1609Troubleshooting Guide Troubleshooting Guide Model Parts ListVacuflush Status Panel Parts List 35 HTS-EC Parts List 60 HTS-EC Parts List 90 HTS-EC Parts List Vacuum Generator Not Shown Parts List Discharge PumpWiring Parts Distributors Dometic Corporation and Sales Offices Page Dometic AB Manufacturers ONE-YEAR Limited WarrantyDometic Corporation