
|
|
|
|
|
|
zConvert a speaker stand into a lighting tree.
z48” crossbar has 4
zWeight Rating: 60 lbs. (27.2 kg)
zParts:
1) | 48” tube with end plugs | 1) | |
2) | Universal fittings | 1) | Hardware packet |
zAdd a second tier to your lighting tree.
zEach 24” crossbar arm has 2
zWeight Rating: 20 lbs. (9.1 kg) per arm
zParts:
2) 24” tubes with end plugs 2)
2) Universal fittings | 1) Hardware packet |
2.
3.
STEP 1: Set up tripod stand following enclosed instructions.
STEP 2: Assemble each
STEP 3: Slide
STEP 4: Optional: Slide one Universal Fitting for dimmer packs on the Tube - place on either side of the
Handknobs.
STEP 1: Set up tripod stand following enclosed instructions.
STEP 2: Follow
STEP 3: Optional: Follow
STEP 4: Slide closed end of
STEP 5: Slide
STEP 6: Follow
STEP 7: Raise height of lighting tree following enclosed tripod instructions.
|
| Special Instructions |
|
|
|
|
|
|
z Make a lighting tree 24” taller. |
5.
6.
2
STEP 5: Slide
STEP 6: Assemble mounting Hardware through par can yoke or other lighting effect in order shown (bolt, washer, saddle, tube, saddle, washer,
STEP 7: Raise height of lighting tree following enclosed tripod instructions.
z Parts: |
1) 24” tubes with end plug |
and connector |
1) Hardware packet
STEP 1: Place Extension Tube over top of the speaker stand.
STEP 2: Tighten
1.Follow all Setup and Special Instructions on enclosed Tripod Stand sheet.
2.Universal Fittings are intended for use with dimmer packs only - DO NOT USE WITH LIGHTING FIXTURES.
3.Distribute weight equally over Lighting Tree System.
4.Check that handknobs are secure when supporting equipment and always loosen handknobs with caution.
3