Features

Plastic Stowaway Light Base

91020, 91022 (2 wire) 91021 (3 wire)

Installation Instructions

Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS
Form Number 69345 Rev. C	03-12

This base is designed for use with the Attwood 3900 Series All- Round Lights And Attwood Combination Sidelights.

For 12-volt D.C. only.

CAUTION

To prevent personal injury, always disconnect the power source when installing or servicing this product. Always remove the boat from the water before using 120 VAC power tools.

INSTALLATION INSTRUCTIONS

Note: For technical detailed positioning follow COLREG 72 or ABYC A-16. Below is a simplified drawing of placement of navigational lights in relationship to one another. (Figure 1)

Figure 1

1.Position the light base either on the bow for combination sidelights or the stern or gunwale for all-round lights. Be sure that the mounting surface is flat and that the selected area will accommo- date the base dimensions. Base angle and position must properly place light used in base.

2.Using the template provided, locate the base center line parallel to the boat fore-and-aft center line and carefully mark the center installation hole and the screw holes. Drill 1-3/8'' diameter hole for #91022 or 1-1/4" diameter hole for #91020 and #91021 being very careful not to crack or break the gelcoat finish, and sand to remove burrs from around the edge of the hole. Drill the pilot screw holes. (Figure 2)

Note: On some installations you may have to connect the wires then push them back through wire hole prior to screwing down the base.

3.Apply sealant between deck and light base. Fasten base in place with stainless steel screws.

CAUTION

Do not overtighten screws.

Figure 2

3/4"

1-3/4"

1-3/8"

Oval Template

15/32"

15/16"

Forward

1-1/2"

3/4"

27/32"

1-1/4"

Round Template

Forward