Pelco ips-rdpe-2 manual Operation, Upload Icon

Page 17

Operation

To view video, control pan/tilt/zoom, or upload revised operating software and language files to a positioning system, do the following:

1.Open the door of the IPS-RDPE-2. Opening the door will automatically disconnect the controller at the head-end and trigger an audible alert at the IPS-RDPE-2 site.

NOTE: The audible alert indicates that the data port is in service mode and also serves as a reminder to close the door after servicing the positioning system.

2.Connect the RJ-45 connector of the IPS-CABLE (not supplied) to the RJ-45 port in the IPS-RDPE-2. The audible alert will stop.

To service and/or test the positioning system, refer to the manual supplied with IPS-CABLE. The IPS-CABLE manual includes instructions for on-site setup, testing, and software uploads using the RJ-45 port of the IPS-RDPE-2 with a Windows-based PC, Palm OS-compatible hand- held, or iPAQ pocket PC.

WARNING: To prevent damage to the positioning system, never cycle power or attempt control of the system during the upload process. The upload process is not complete until the system reboots.

NOTE: During software/language file upload, an icon will appear on the monitor at the head-end to indicate data is being transferred to the positioning system (refer to Figure 12). The default setting for data transmission is 115.2 kb per second. Noisy and long-run connections will slow the transmission rate.

3.When servicing/testing is completed, disconnect the IPS-CABLE. The audible alert is triggered. Close the door to the IPS-RDPE-2 to stop the audible alert and return control to the head-end.

Figure 12. Upload Icon

C2473M-C (8/06)

17

Image 17
Contents IPS-RDPE-2 Remote Data Port Page List of Illustrations ContentsImportant Safety Instructions Description Required AccessoriesWall Mounting Mounting InstructionsPole Mounting Refer to for a layout of the data port box connectors Cable/Wire Requirements and Connector LocationsWiring Diagrams Positioning System IPS-RDP PTZ Control Software Upload Positioning System Software Upload Positioning System UTP Receiver Control System AT Control System VC-UTP RX- RX+ TX- TX+ UTP- UTP+ VAC+ Upload Icon OperationElectrical SpecificationsProduct Warranty and Return Information ISO9001
Related manuals
Manual 20 pages 57.65 Kb