Metra Electronics installation instructions Installing and Testing the MITO-01

MITO-01 MITO-01

INSTALLING AND TESTING THE MITO-01

1.With all connections completed to the radio, plug the corresponding harnesses into the MITO-01.

2.Cycle the key by turning the ignition on then back off, then back on again to test the radio for proper operation.

3.If the subwoofer or front door speakers are too loud you can adjust the output by following the steps below:

A. Locate the end of the MITO-01 with the 14 way Molex connector.

B. There are 2 potentiometers next to the Molex connector, the one closest to the Molex connector is the subwoofer control and the other one is the front door speaker control.

SUBWOOFER CONTROL

FRONT DOOR SPEAKER

CONTROL

C. Using a small blade screwdriver turn the potentiometer of the speaker you want to adjust either clockwise to make it louder or counterclockwise to lower the volume.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps toward a better tomorrow.

Rev. 03/11/10 INSTMITO-01

1-800-221-0932 www.axxessinterface.com

MITSUBISHI DATA BUS INTERFACE

MITO-01

INSTALLATION INSTRUCTIONS

*READ IMPORTANT WARNING ON PAGE 2 BEFORE ATTEMPTING ANY INSTALLATION

The MITO-01is designed to be used in vehicles listed in the applications that have the Rockford Fosgate audio sys- tem.The Rockford Fosgate system uses a digital signal to turn on the amplifier. The MITO-01 supplies that digital sig- nal to turn the amplifier on and also eliminates the “COM ERROR” message on the display when the OEM radio is removed. When installing a radio that has navigation built in, the MITO-01 can supply VSS (Vehicle Speed Sense), Parking Brake, and Reverse; however Reverse is not avail- able on manual transmission vehicles.

The radios speaker wires will provide the audio for the dash and rear speakers while the rca’s will provide the audio to the amplifier to power the door speakers and woofer.

INTERFACE COMPONENTS

•MITO-01 Interface

•14 Pin Harness with RCA’s

•Vehicle side harness

•2 Pin harness

1-800-221-0932 www.axxessinterface.com

5 ©Copyright 2010 Metra Electronics Corporation ©Copyright 2010 Metra Electronics Corporation