DigiTech CM-2 manual Hook-and-loop Pedalboard Pad

Page 14

Hook-and-loop Pedalboard Pad

To attach the Pedalboard Pad, do the following:

. Peel off the existing rubber skid pad from the bottom of the pedal.

2.Peel the adhesive protector from the back of the Pedalboard Pad. . Apply the Pedalboard Pad to the bottom of the pedal.

10

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Page Declaration of Conformity Warranty Page Introduction Included ItemsPage What Does This Do? Amount of overdrive gain shortly you will need to replace the battery Page Amplifier Setup Battery Operation Foot Switch HardWire Performance Accessories Hook-and-loop Pedalboard Pad Foot Switch Glow Sticker StompLock Specifications Page Page South Sandy Parkway Sandy, Utah PH 801 FAX 801
Top Page Image Contents