Pioneer PD-F957 specifications Location, Display, and unplug the power cord PRB1273 En

Page 5

CAUTIONS REGARDING HANDLING

Location

Install the player in a well-ventilated location where it will not be exposed to high temperatures or humidity.

Do not install the player in a location which is exposed to direct rays of the sun, or near stoves or radiators. Excessive heat can adversely affect the cabinet and internal components. Installation of the player in a damp or dusty environment may also result in a malfunction or an accident. (Avoid installation near cookers etc., where the player may be exposed to oily smoke, steam or heat.)

Do not install the player on a tottered stand nor in an unstable or inclined place.

Condensation

When this unit is brought into a warm room from previously cold surroundings or when the room temperature rises sharply, con- densation may form inside, and the unit may not be able to attain its full performance. If this occurs, allow the unit to stand for about an hour or raise the room temperature gradually.

Precautions regarding installation

÷Placing and using the compact disc player for long periods on heat-generating sources such as amplifiers will affect perfor- mance. Avoid placing the player on heat-generating sources.

÷Install this compact disc player as far as possible from tuners and TV sets. A compact disc player installed in close proximity to such equipment may cause noise or degradation of the pic- ture.

÷Such noise may be particularly noticeable when an indoor an- tenna is used. In such cases, make use of an outdoor antenna, or turn off power to the compact disc player.

÷Please place this unit on a level surface.

Cleaning the player

To clean the PLAYER, wipe with a soft, dry cloth. For stubborn dirt, wet a soft cloth with a mild detergent solution made by dilut- ing one part detergent to 5 or 6 parts water, wring well, then wipe off the dirt. Also use a dry cloth to wipe the surface dry. Do not use volatile liquids such as benzene and thinner which are harmful to the unit.

Storing discs

÷Discs are made of the same kinds of plastic used for conven- tional analog audio records. Be careful not to allow discs to warp; always store discs in their cases vertically, avoiding loca- tions with high heat or humidity, or extremely low tempera- tures. Avoid leaving discs in cars, since the seat of a car in direct sunlight can become unbelievably hot.

÷Always read and abide by the precautionary notes listed on disc

labels.

CD lens cleaner

The player's pickup lens should not become dirty in normal use, but if for some reason it should malfunction due to soiling, consult your nearest PIONEER authorized service center. Lens cleaners for CD players are commercially available, but special care should be exer- cised in their use since some may cause damage to the lens.

Cleaning and handling compact discs

÷The presence of fingerprints or smudges on the surface of the disc will not directly affect the recorded signals, but depending on the degree of contamination, the brightness of the light reflected from the signal surfaces may be reduced, causing degradation of sound quality. Always keep your discs clean by wiping them gently with a soft cloth from the inner edge to- ward the outer periphery.

÷If a disc becomes very dirty, dip a soft cloth in water, and after wringing it out well, wipe the dirt away gently, and then remove any water drops with another soft, dry cloth.

÷Do not use record cleaning sprays or anti-static agents on discs. Also, never clean discs with benzene, thinner, or other volatile solvents, since damage to the disc surface may result.

Record cleaning

sprays Thinner Benzene

With this unit, use a Compact Disc carrying the mark shown below. Do not use other disc, for this may result in malfunc- tion or damage.

÷When holding discs, do not touch their signal surfaces. Hold by the edges, or by one edge and the center hole.

÷Do not affix gummed labels or tape to the label surfaces. Also, do not scratch or damage the label.

÷Discs rotate at high speed inside the player. Do not use dam- aged (cracked or warped) discs.

÷Do not play a CD with a special shape (having other shape than a circular disc, such as a heart shaped disc). Otherwise mal- function may occur.

'

Re-transporting

When re-transporting this unit in the future, remove all discs from the rack. Turn off the STANDBY/ON switch, wait for "OFF" to go out from

the display, and unplug the power cord.

5

<PRB1273> En

Image 5
Contents Important Notice ContentsImportant Safety Instructions For Canadian model Information to UserPUT Batteries Into the Remote Control Unit Confirm Supplied AccessoriesBefore YOU USE the Player HERE’S What YOU can doLocation Display, and unplug the power cord PRB1273 EnO Interface ConnectionsFront Panel Names of PartsDisplay ÷The numbers in parenthesis P. are reference pagesNames of Parts Remote Control UnitRemote Control Operations To remove the discs Basic Operations To select a play modeTo listen in order from the first track To select the disc and trackHood can be opened or closed during playback Playing a disc in the Single Loader slotBasic Operations OPEN/CLOSE CessClear Mode ClearVarious Operations Various Operations To play a track you want to hearRepeat OFFTo playback tracks/discs at random Random play Ther play or stop modePress Random during ei To stop random play, pressTo program tracks/discs in a desired order Program play Ing stop modeFollowing operations can only be performed during stop mode Best To store your favorite tracks Best playBest Previous HI-LITE To scan quickly through tracks on a disc HI-LITE scanPress Time during play- back To use the Time buttonTIME/CHARA Cursor Disc Title InputTitle Input Clear Title Input Disc Title ModificationPress the Clear button Press a digit button to enTo search a disc by the Disc title CD Text Data Display CD Text compatible data onlyTitle Display Press the Title DisplaySELF-DIAGNOSTICS Function TroubleshootingPOWER-CORD Caution Display on the unit0 0 4 2 1 1 4 0 Accessories SpecificationsGeneral Audio section