Roland DC-13 owner manual Switch Functions

you want to vary the volume of the guitar using the volume control on the guitar, use the direct guitar output on the body of the guitar itself. This is a standard 1/4” jack usually found next to the 24-pin connector on a G-series guitar.

7 . Hex Fuzz: This connector outputs the line-level hex fuzz distortion guitar signal

generated by the internal hex fuzz circuitry inside a Roland G-202, G-303, G- 505, or G-808 guitar. Because this is a line level signal, and because this is a distorted signal, the output level is very high. Like the Guitar Line Output, the Hex Fuzz output does not respond to changes in volume using the guitar’s master volume knob.

_______________________________________

SWITCH FUNCTIONS

The DC-13 changes		some the functions of	[When using a G-Series Guitar]
vintage G-Series controllers to match new, 13-pin			G-202, 303, 505, 808
functions.
• Master	Volume knob is now for Guitar
Volume only. This knob changes the
volume of the Guitar when a cable is
hooked to the standard 1/4” output jack
on the guitar.
• Guitar Tone		Knob controls the tone of
the guitar’s normal sound.
• Filter	Knob, or CV#1, becomes the
volume control for Synth A.
• Resonance		Knob, or CV#2, becomes
the volume control for Synth B.			G-707

•Mode Switch becomes SW1 and SW2.

When the mode switch is switched down, the receiving synth receives a “SWITCH 1” command. When the mode switch is switch up, the receiving synth receives a “SWITCH 2” command. This function works best when the switch is rapidly turned on and off, moving away from and quickly returning to the center position (off).

The position for Mode I on a vintage G-Series controller, is now “SWITCH 1.”

The position for Mode III on a vintage G-Series controller, is now “SWITCH 2.”

The center position, or Mode II on a vintage G-

Series controller, is now off.