DigiTech RP50 manual Stereo Operation

Page 10

Stereo Operation

For stereo operation connect the guitar to the Input of the RP50. Connect a TRS stereo “Y” cord or a pair of stereo headphones to the RP50’s Output. When using a “Y” cord, connect one end of the “Y” cord to the input of one amplifier or channel of a mixer.

Connect the second end of the “Y” cord to a second amplifier, or second channel of a mixer. If connecting to a mixing console, set the pan controls of the mixer hard left and right to retain stereo separation. To emulate a guitar cabinet sound when using the RP50 with a mixer or headphones, you can enable Global Cabinet Modeling (see page 20).

Guitar Amp Input / Effect Return

Headphones or

Stereo TRS "Y" Cable

Connected to Output

Input

6

Page 9 Page 11
Image 10
Page 9 Page 11
Contents User’s Guide Electromagnetic Compatibility Declaration of Conformity Warranty Introduction Front Panel Page Rear Panel Input Connect your instrument to this jackMaking Connections Mono OperationStereo Operation Applying Power Battery PowerPlay Mode AC PowerPresets About the RP50Tuner Display shows the note playedEditing/Creating Presets BypassEffect LEDs Storing/Copying a Preset Effect Definitions Preset LevelPickup/Wah Compressor Amp/Cabinet ModelingNoise Gate Chorus/ModChorus C1-C9 Vibrato b1-b9 Pitch Shift H1-H9 Delay ReverbDrum Machine Other FunctionsExpression Pedal Global Cabinet ModelingFactory Reset All such data will be lost foreverSpecifications AppendixPreset List User/Factory Stacked Bad Dog
Top Page Image Contents