DAT can receive signals from device “Source”, “B”, “C”, or “D” INPUTS depending on where you position this knob.
OUTPUT SELECT B: This four-position knob works like the output select “A” knob described above. For example, if the “B” RCA OUTPUTS on the back panel are used for a cassette recorder, the recorder can receive signals from stereo device Source, “A”, “C”, or “D” INPUTS.
OUTPUT SELECT C: The SRM-80A’s “C” OUTPUTS can receive signals from device “Source”, “A”, “B”, or “D” INPUTS depending on where you position this knob. For example, if the “C” RCA OUTPUTS on the back panel are used for a MiniDisc recorder, the re- corder can receive signals from stereo device “Source”, “A”, “B”, or “D” INPUTS.
OUTPUT SELECT D: The SRM-80A’s “D” OUTPUTS can receive signals from device “Source” “A”, “B”, or “C” INPUTS. For ex- ample, if the “D” RCA OUTPUTS on the back panel are used for a CD player/recorder, the recorder can receive signals from stereo de- vice “Source”, “A”, “B”, or “C” INPUTS.
MONITOR SELECT: This fi ve-position knob allows you to select which device you will hear through your speakers and headphones, the main console or soundcard mix (Source), or the output of any devices “A” through “D”.
LISTENING LEVEL: Controls the loudness level you hear through your speakers. It does not affect the signal going to any of the stereo devices connected to the SRM-80A.
MONO: Changes the sound you hear through your speakers (not in the Headphones) from
stereo to monaural.
DIM: Attenuates the loudness of your speakers by about 15 dB, without affecting the level of the signals going to any of the stereo devices or headphones connected to the SRM-80A. This is a very useful feature if you are interrupted while monitoring, mixing, or dubbing.
MONITOR LEVEL: This high-resolution, 40 x 2 LED bar graph meter allows precise pre-fade level calibration for all stereo devices con- nected to the SRM-80A.
METER MODE: Located to the right of Mon- itor Level Meter, this switch can be set for the meter to display AVG (VU) or Peak Mode.
SPEAKERS A, B, and C: Selects between amplifi er / speaker outputs A, B, or C.
TRIM LEVELS: Adjusting these “Set Once” controls allows you to set all three pairs of am- plifi ers/speakers to the same listening level.
HEADPHONES: Plug your headphones in here. The high-power headphone amp pro- vides excellent audio quality and can drive low-impedance phones with ease. It may be wise to disconnect your headphones to avoid damage when not in use.
HEADPHONE LEVEL: Adjusts the listening level of the headphones.
REAR PANEL CONTROLS AND CONNECTIONS
GROUND LIFT: Allows separation of chassis ground from audio ground and can be used to reduce hum or buzz. Remember, never remove the third prong on the SRM-80A’s AC
