Crest Audio Professional Power Amplifier, CA18, CA9, CA6, CA12, CA4, CA2 owner manual Front Panel

Front Panel

1 2 3 4 5 6 7 8 9

Professional Power Amplifier

1.	Rack Mounting Ears.	Never try to hold the
Two front panel mounting holes are provided on each mounting ear.
		circuit breaker/power
2.	Optional Rack Handles.	switch in the “ON”
		position if it won’t stay
Available from your authorized Crest Audio supplier.
		there itself!
3.	Fan Outlet Grills.

CA Series amplifiers are cooled by two, rear-mounted fans. Cool air flows over the heat sinks and exhausts through the front grills. Make sure these outlets remain clear to allow unrestricted air flow.

4. AC Power Switch/Circuit Breaker.

CA Series amplifiers have a front-panel combination AC switch and circuit breaker. (No fuses are used.) If the switch shuts off during normal use, push it back to the “ON” position once. If it will not stay on, the amplifier needs servicing.

5. Signal LED.

Illuminates to indicate that a signal (above a minimum threshold) is present at the amplifier input, and that the signal is being amplified.

6. Clip LED.

Illuminates at the clipping threshold. Continuous illumination also indicates that ACL (Active Clip Limiting) protection circuitry is engaged.

7. Active LED.

Indicates that AC power is connected and the amplifier is turned on.

8. Protect LED.

Indicates that the channel is in Protect mode (speakers disconnected by output relay).

9. Input Attenuators.

Two input attenuators adjust level for their respective amplifier channels. In Bridged Mono Mode, both attenuators are used to control signal level and must be adjusted to the same setting.

Page 6	Crest Audio CA Series Power Amplifiers
	Models CA2, CA4, CA6, CA9, CA12, CA18