Ccl

FRONT PANEL CONTROLS

socket to plug in a bass guitar.

INPUT

GAIN

control + CLIP / LIMIT LED to adjust the input level.

LIMITER

switch + 2-colored CLIP / LIMIT LED to compress the signal within the preamp.

LOW BOOST

switch + LED to boost the low end.

BASS

control to boost / cut low frequencies.

PUNCH

control for boosting/cutting deep mids.

MID FREQ.

control to determine the midrange frequency.

MID LEVEL

control to boost / cut the frequency adjusted with the MID FREQ. control.

NDATTACK

control for boosting/cutting high mids.

TREBLE

control to boost / cut high frequencies.

HIGH BOOST

switch + LED to boost the highs.

MUTE

switch + ON / MUTE LED mutes the signal of all outputs except the PHONES and TUNER socket. To avoid

switching noise use the MUTE switch only while no audio signal is being played back.

MASTER

control determines the main volume level.

PHONES

socket for connecting headphones (min 200 Ohm).

REAR PANEL

ENGLISHRetractable handle and wheels make it easy to transport your Warwick Combo.

MAINS IN AC

terminal with integrated fuse compartment for connecting the amplifier to mains.

POWER

switch for turning the amplifier on and off.

GROUNDLIFT

switch disconnects the protective ground line from signal ground. A humming loop may occur when several

devices are hooked up to the same protective ground line and connected by line cables. Use GROUNDLIFT

TUNER OUT

to eliminate humming loops.

to connect to a tuner, active when MUTE is enabled.

LINE OUT

socket allows connecting additional power amplifiers or active cabinets.

EFF. LOOP

for the insertion of an effects unit. Connect EFF. SEND with the input and EFF. RETURN with the output of the

DI PRE / POST

effects device.

switch to route the signal to

DI OUT

socket PRE (pressed, direct signal from the bass) or POST (released, signal affected by equalizer or effects

SUBSONIC

loop). Symmetric XLR out to connect to e.g. a mixing console.

switch to cut low frequencies from the power amp ( CCL ND: signals below 120 Hz).

SPEAKER OUT

to connect the amplifier to the speaker.

HORN ATT.

to control horn volume separately.