CONNECTION
Connect microphones to the MX34c via balanced XLR cables.
Stereo auxiliary sources such as the output from another mixer, AM/FM tuners, CD Players, and MP3 players may be connected to the AUX IN via a stereo 1/8” (3.5mm)
Connect the STEREO OUT to the Input of your recording device also using a stereo 1/8” (3.5mm)
If you wish to use AC power for the MX34c, connect the Rolls PS27 12VDC power supply.
OUTPUT LEVEL
|
|
|
| MIC |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| LINE |
|
|
|
|
|
|
|
|
| INPUTS | ||||
12 VDC POWER |
|
| STEREO AUX |
|
|
| ||||||||||||
|
|
|
|
| ||||||||||||||
|
|
|
|
|
|
|
|
|
| |||||||||
|
|
| OUT IN | CHANNEL | CHANNEL | |||||||||||||
+ |
|
|
|
|
|
|
| |||||||||||
|
|
|
|
|
|
| 2 |
| 1 |
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
OPERATION
Once your MX34c is properly connected, apply power by pressing in the POWER button on the rear panel. The blue pwr LED on the front panel should light.
If you are using condenser type microphones, apply the phantom power to the desired channels. Test the microphone levels by speaking into the microphones at a normal operating volume, and adjust the Mic Level controls until you achieve desired levels. Adjust each Pan control to place the signal in the stereo field.
Adjust the Headphone Level control for a comfortable listening volume.
For best results, we recommend recording a couple of test runs to ensure you have proper levels set.
HEADSET
MIC 1/8”
c
To camera input or other mic or line level stereo input
Connect STEREO headphones or earphones to the 1/8” (3.5mm) HEADPHONE OUTPUT located on the MX34c front panel.
NOTE: ON CONNECTING A WIRELESS MIC TO THE AUX INPUT
When the signal becomes weak and distorted, or the pwr LED dims, the batter- ies will need replacing. See page 2; Battery Installation for details.
DO NOT CONNECT A MONO PLUG TO THE AUX IN OR STEREO OUTPUT. DO- ING SO WILL RESULT IN SIGNAL LOSS OR DAMAGE TO THE MX34c.
If you need to connect a MONO signal (like the output of a wireless microphone) to the AUX IN of the MX34c, you will need to make or purchase a MONO TO STEREO cable.Shown here is a diagram of this cable’s wiring.
3
MONO PLUG
Tip and Ring are wired together, then connected to the Tip of the Mono Plug.
4