Nady Systems SPM-6300 owner manual Front Controls and Connections

FRONT CONTROLS AND CONNECTIONS

	CHANNEL SECTION
	(1) MIC INPUT
	This electronically balanced XLR input is designed to accept
	signals from any balanced or unbalanced low impedance (Low Z)
	microphone. The XLR jack is configured for: Pin1 = ground, Pin2
(3)	= positive (+), Pin3 = negative (-).
	(2) LINE INPUT
	This 1/4" input is designed to accept balanced or unbalanced line-
	level signals such as those from keyboards, drum machines, or
	samplers. If a balanced signal is to be connected to the line input,
	then a 1/4" TRS (stereo) phone plug should be wired for: Tip =
	positive (+), Ring = negative (-), Sleeve = ground.
(4)	(Note: Only the Mic or the Line input of a given channel should be
	connected at one time. Do not connect both at the same time.)
	(3) TREBLE EQ
	Turn to the right to boost high frequencies, adding crispness too
(5)	percussion from drum machines, cymbals, and synths. Turn to the
	left to cut these frequencies, reducing sibilance or hiss. The
	control has a shelving response providing 15dB of boost or cut at
	10kHz.
	(4) BASS EQ
	This control provides 15dB of boost or cut at 90Hz. Boosting the
(6)	Bass control, by turning to the right, can fatten the sound, adding
	warmth to vocals or extra punch to bass, drums and synths. Turn
	to the left to reduce stage rumble, hum, or to improve a mushy
	sound. Cutting the Treble and Bass controls, then pushing up the
	subsequent volume control is equivalent to a mid range boost.
	(5) EFFECT CONTROL
(7)	The Effect control adjusts the signal level sent by each channel to
	the internal Echo Effects DSP (Digital Sound Processor). The
	Effect controls are post Channel EQ and the signal level sent to
	the EFF bus will not be affected by the channel volume settings.
	This control also adjusts the level of the un-effected signal sent to
	the Effect Send (13) output.
	(6) MONITOR VOLUME
	The Monitor Volume control adjusts the channel signal level sent
(2)	to the Monitor Master Volume (16) when the Power Amp
	Selector Switch (18) is set to Monitor-Main. This control can be
	adjusted to set the desired monitor mix. The Monitor Volume
	control is not active when the selector switch is set to Left-Right.

(7) LEFT-RIGHT / MAIN VOLUME

The Left-Right Volume control adjusts the channel signal level sent to the master L-R/Main Volume control (15). This control can be adjusted to set the desired level for the channel in the mix.

(1)

5