N T R O L S a N D C O N N E C T I O N S

C O N T R O L S A N D C O N N E C T I O N S

FRONT PANEL

(1)(2)

1.INPUT GAIN CONTROL

Adjusts the input level of the audio signal to the unit.

2. INPUT LEVEL DISPLAY

This 4-segment bargraph displays the input level. The clip LED's will light at 3dB below clipping.

3. VALUE INDICATOR

Whenever the SDR-260 is powered up, this displays the last chosen effect number. In use, the display indicates different alphanumeric information, depending on the mode selected.

•In NORMAL MODE it indicates which of the 255 effects (1-255) has been selected.

•In EDIT MODE it indicates the editable value of the parameter (0-127).

•In EQ MODE it indicates the editable value of the parameter (0-127).

•In STORE MODE it indicates the address (1-20) being saved.

•In LOAD MODE it indicates address (1-20) being loaded.

(3)

(5)

(6)

(4)

(7)

4.PUSH & ROTARY CONTROL KNOB

This is the tool used to control the SDR-260

5.PARAMETER EDIT INDICATORS

Each indicator will light when the corresponding parameter is being displayed - Delay/Reverb/HI Patio/Early Reflection Level.

6. STORE INDICATORS

This indicator will light when in STORE MODE

7. POWER SWITCH

Use this switch to power unit ON or OFF. The integrated LED will light when the unit is ON. Before turning on this unit, verify connection to the proper voltage AC source, check all connections and turn down the level controls of equipment connected to the outputs.

REAR PANEL

MIDI IN

AC115V

	POWER INPUT:
	AC115V/230V
	FUSE:
	0.5A, F, 250V	WARNING:	SERIAL
AC230V	0.5A, F, 250V

		TO REDUCE THE RISK OF FIRE OR
		TO REDUCE THE RISK OF FIRE OR
		ELECTRONIC SHOCK, DO NOT EXPOSE
		THIS EQUIPMENT TO RAIN OR MOISTURE

	(13)		(12)
	OUTPUTS		INPUTS
	-10dB	+4dB	-10dB +4dB
RIGHT	LEFT	RIGHTLEFTRIGHTLEFT	RIGHT	LEFT

(8)

(9)

(10)

(14)

(11)

8.AC POWER CORD IEC CONNECTOR WITH INTEGRATED FUSE HOLDER

This standard IEC power cord receptacle is used to connect the AC power to your unit. It features a built-in fuse holder for a 5X20mm, 0.5A/250V slow-blow fuse. If the fuse continuously blows, shut of the unit and have it serviced by qualified service personnel.

9.AC VOLTAGE SELECT SWITCH

Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area: ~115V (60Hz) or ~230V (50Hz).

(Note: use at the improper voltage can damage your unit and void the warranty.)

10. MIDI INPUT PORT

Receives MIDI Program Messages on MIDI Channel 1.

11. INPUTS

Unbalanced 1/4" (6.3mm) and balanced XLR inputs for both left and right channels.

12. INPUTS LEVEL SWITCH

Switches between –10dB and +4dB input level attenuation.

13. OUTPUT LEVEL SWITCH

Switches between –10dB and +4dB output level attenuation.

14. OUTPUTS

Unbalanced 1/4" (6.3mm) and balanced XLR outputs for both left and right channels.