WARNING
The capsule is the heart of your condenser microphone. If it become dirty or wet , the sound will be degraded. Never spray any liquid on the microphone head. Always use a foam windscreen if you talk or sing close to the microphone grill screen.
USING THE OPTIONAL MICROPHONE SHOCK MOUNT
Your SCM Series microphone can be used with the optional Nady
To insert your SCM Series microphone into the
USING THE FOAM WINDSCREEN
The
(Note: Be aware that the foam windscreen will slightly attenuate the high frequency response of the microphone.)
CONNECTING THE SCM 900/910/920
The SCM 900/910/920 can be used in live sound reinforcement and broadcasting and in studio or live recording. It must be powered by 48V phantom power (such as supplied by the optional Nady
Make sure to set the
The SCM 900/910/920 can be connected to your mixer or phantom power supply using a standard balanced
1.Connect the SCM 900/910/920 to the
2.Connect the
3.Connect the
4.Turn on the
5.Slowly turn up the channel gain in your mixer to the desired level
SERVICE
(U.S.) Should your Nady microphone require service, please contact the Nady Service Department via phone at (510) 652- 2411 or
(INTERNATIONAL) For service, please contact the Nady distributor in your country through the dealer from whom you pur- chased this product.
Do not attempt to service this unit yourself as it will void your warranty
SCM 900/910/920 SPECIFICATIONS
Type: | True condenser | Recommended load impedance: | ≥1000 Ohms |
| phone with1.0 inch diaphragm | Max. SPL (1% THD @1000Hz): | 125dB |
| (SCM 920: dual diaphragm) and FET pre- | Equivalent noise level to |
|
| amplifier. | IEC | |
Polar pattern: | SCM 900/910: Cardioid | S/N ratio re 1Pa: | 76dB |
| SCM 920: Selectable cardioid, & omnidirectional | Power requirement: | +48VDC phantom power |
Controls: | SCM 910: Selectable | Current consumption: | <3mA |
| SCM 920: Selectable | Connector: | |
Sensitivity: | SCM 900/910: | Mic cable: | |
| SCM |
| (not supplied) |
Frequency range: | SCM 920:10mV/Pa | Size: | Diameter: 2.0" (50.5mm), |
30 to 16,000Hz |
| Length: 7.5" (190mm) | |
Low cut: | 100Hz, | Net weight: | 17.8oz (500g) |
Impedance: | < 200 Ohms | Specifications subject to change for improvement purposes | |
|
|
12/22/00