Before you start, Installing the speaker stands

Thank you for buying this Pioneer product. This speaker stand should only be used with the S-7EX Pioneer speaker system. Please read through these operating instructions for proper assembly and use. After you have finished reading the instructions, put them away in a safe place for future reference.

Before you start

Before setting up your speaker system, we recommend reading the operating instructions for your system thor- oughly.

•Only use the screws supplied when fixing the speaker to the speaker stand.

•Do not place the stand on an unstable and/or sloping surface. The stand and speaker may fall and cause injury.

•Do not use with any speaker system other than the one for which the unit was designed. The stand may collapse and be damaged and/or the speaker may fall and cause injury.

•When moving the speaker and stand, first remove the speaker from the stand, and then move the stand, holding it by the two stems.

Installing the speaker stands

Place the stand on a stable, level surface; placing the stand on an unstable surface can be dangerous.

Adjust the position as necessary to obtain optimal sound from your system.

•Pioneer assumes no liability whatsoever for damages resulting from assembly, improper mounting, insuffi- cient reinforcement, misuse of the product, acts of nature, etc.

Assembling the speaker stands

Assemble the speaker stands as illustrated below. Please note that a flathead screwdriver will be necessary for assembly. The following illustration shows the fully assem- bled speaker stand:

Screw slots

Speaker supportfor securing speaker

Stand stems

Stand base

•Align the screw slots on the stand base and screw holes on the speaker support with the screw holes in the two stems, then insert the screws and tighten.

The screw slots allow you to fine-tune the positioning of the speaker.

	Screws (Bind head, M6xL55)
	55 mm
Speaker	Black
support	(SBA6051)
Stand	Please note that sunken
stems	screw holes are provided
	in the speaker support.
Stand
base

Screws (Bind head, M6xL40)

	Nut
	Spike (SBA6053)	40 mm
	Spike base	40 mm
	Spike base
	(SLA1057)	Black
		(SBA6054)

•Make sure you assemble the stand on a flat surface that is relatively soft (such as a carpet).

•Make sure the screws are inserted in the screw holes as shown above (with the screw head hidden) when securing the speaker. Improper setup could result in damage or injury if the speaker falls from the stand.