Supplied Hardware, Fixed Installation

INSTALLATION

SUPPLIED HARDWARE

	•	4 rubber feet. For stand-alone installation.
	•	1 rackmount bracket, long. For half-rack (single unit) instal-
ENGLISH		lations.
ENGLISH	•	1 rackmount bracket, short. For half-rack (single) or du-
	•	1 rackmount bracket, short. For half-rack (single) or du-
		al-mount installations.
	•	2 straddle brackets. For dual-mount or fixed installations.
	•	12 bracket screws, 1/4 in. (6 mm). For securing the brackets
		to the chassis.
	•	4 rackmount screws, 1 in. (2.5 cm). For mounting the unit in
		a rack.
	•	4 plastic washers. For use with the supplied rackmount
		screws.
	•	4 wood screws, 1/2 in. (1.25 cm). For fixed installations.

2.Attach the short rackmount brackets to the outsides of the com- bined units with eight (8) of the bracket screws.

3.After attaching the brackets, mount the unit in an equipment rack using the supplied rackmount screws and plastic washers.

Bracket Screw

Rackmount Screw

RACKMOUNT INSTALLATION

Wood Screw

STAND-ALONE INSTALLATION

Adhere the four (4) supplied rubber feet to the bottom of the unit at each corner. This will keep it from sliding and protect the table surface.

The SCM268 can be mounted as a single unit or dual-mounted with either another SCM268 or another Shure half-rack unit such as the SCM262 or DFR11EQ. Attach the rackmount brackets using one of the following methods:

Single unit (half-rack) installation:

1.Attach the short and long rackmount brackets to the SCM268 with eight (8) of the supplied bracket screws.

Dual-mounted installation:

1.Connect the two units together side-by-side using two (2) straddle brackets. The brackets should straddle the recessed edges on on the top and bottom of each chassis. Fasten them using eight (8) bracket screws.

NOTE: Be sure to use both straddle brackets-one on the top and one on the bottom.

FIXED INSTALLATION

To permanently affix the SCM262 above or below a table, shelf, or counter top, use the following steps:

1.Fasten the straddle brackets to the recessed edges of the chassis using four (4) bracket screws.

Top mount: Fasten the straddle brackets to on the bottom of the unit

Hanging mount: Fasten the straddle brackets to the top of the unit.

2.Fasten the straddle brackets to the surface using the four (4) sup- plied wood screws.

TOP MOUNT

HANGING MOUNT

INSTALLATION