Manual Channel and Group Selection (receiver only)
Using the receiver to scan for a channel is the best way to find the best frequency for your system. However, for multiple system setup, you may need to manually set the group number.
1.Press and hold the channel button.
2.Hold the button until the channel or group display begins flashing.
3.Release and press the button again to advance the setting.
At the desired channel or group number, wait for the flashing to stop. This activates the new setting.
4.Transfer the new frequency setting to the transmitter using the automatic sync function.
group display | channel display |
3 s
channel
channel
channel
channel | 6 s |
|
channel 
channel
channel
Locking and Unlocking Controls
Locking the system controls prevents accidental muting or channel adjustment during performances.
Transmitter
To lock the controls: With the transmitter off, hold the power button down until the green LED flashes (~5 seconds)
To unlock the controls: With the transmitter on, hold the power button down until the green LED flashes (~5 seconds)
Receiver
To lock the channel: Hold the channel button until the numbers flash (~10 seconds)
To unlock the channel: Hold the channel button until the numbers flash (~5 seconds)
5