Crate Amplifiers manual CPB150 Technical Specifications

Page 8

CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier

CPB150 TECHNICAL SPECIFICATIONS:

Output Power Rating

Mono

150W RMS @ 10% THD @ 8 ohms

 

Stereo

75W RMS @ 10% THD per side @ 4 ohms

 

 

 

Input Impedance

Instrument

700k ohm

 

CD

22k ohm

 

Line In

22k ohm

 

 

Total System Gain (all controls @10)

 

 

Instrument

91dB

 

CD

33dB

 

Line

34dB

 

 

Maximum Input Signal Accepted

8 volts peak to peak

 

 

 

Tone Controls

Low

20dB range @ 110Hz

 

Mid

15dB range @ 1kHz

 

High

20dB range @ 10kHz

 

 

 

Power Requirements

 

120 VAC, 60Hz, 35VA

 

 

100/115VAC, 50/60Hz, 35VA

 

 

230VAC, 50/60Hz, 35VA

 

 

 

Dimensions

 

3.2” H x 10” W x 5.6” D

 

 

 

Weight

 

4.6 lbs.

The CPB150 is housed in an anodized aluminum chassis: occasionally wipe it clean with a lint-free cloth.

Never spray cleaning agents onto the unit. Avoid abrasive cleansers which would damage the finish.

Crate continually develops new products, as well as improves existing ones. For this reason, the specifications

and information in this manual are subject to change without notice.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequen- cy energy and, if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. However, there is no guarantee that interference will not occur in a par- ticular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this device not expressly approved by SLM Electronics could void the user’s authority to operate the equipment under FCC rules.

www.crateamps.com

@2005 SLM Electronics, a division of St. Louis Music, Inc • 1400 Ferguson Avenue • St. Louis, MO 63133

47-463-02 • 061305

Image 8
Contents CPB150 Table of Contents CPB150 PowerBlock 150 Watt Stereo Guitar Amplifier Front Panel Rear Panel Using the Effects Loop Jack Adapter and 2 cablesSystem Block Diagram Please refer to Item 9, Speaker OutputsCPB150 Technical Specifications