Numark Industries DM 1835X owner manual DM1835X Rear Panel Diagram

Page 16

DM 1835X

DM1835X REAR PANEL DIAGRAM...

 

11

 

 

 

 

 

 

8

 

8

12

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

10

1

 

 

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

2

3 5

7

7

7

9

7

9

7

9

1.The Balanced Main Outputs are low-impedance XLR type connectors controlled by the Master fader.

2.The Stereo Main Outputs are low-impedance RCA connectors controlled by the Master fader.

3.The Tape Outputs are low-impedance unbalanced RCA jacks which output the program mix and allow you to connect any recording device.

4.The Stereo Zone Outputs are low-impedance unbalanced RCA jacks controlled by the Zone Level controls.

5.The S e n d can be attached to an external effects processor such as a sampler.

6.Mic is the mic input for the Mic Channel and Channel 4.

7.Channels 1-5 Line Inputs are unbalanced RCA jacks. The Line Input is selected with the toggle switch on the front panel. You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E : Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

8.Line/Phono Input switch. Use this to allow line leve equipment to be plugged into your phono inputs giving yo a total of 8 line input options.

9.Phono Inputs on Channels 1, 2 and 3 use unbalanced RCA jacks. Your input signal is fed directly to th D M 1 8 3 5 X's high-quality RIAA phono preamplifiers so us this position only for moving magnet cartridges. Line level sources will overload the sensitive phono preamps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

10.AC Cord. See safety precautions on page 3 for prope treatment of the power cord.

11.Voltage Selector. Set this for the appropriate voltage in your area

12.GND is the grounding lug for turntables 1, 2 and 3 (phono inputs on Channels 1, 2 and 3). Always use this connection (your turntable cable should have a grounding wire).

Numark - The Proven Leader in DJ Technology

©1997 Numark Industries

16

http://www.numark.com

Image 16
Contents DM 1835X Stereo Mixer DM1835X Safety Instructions Index Features CongratulationsNumark The Proven Leader in DJ Technology System Precautions Important InformationDM1835X Front Panel Diagram DM1835X Panel Diagram Peak Sound LED greenBeatkeeper Operation Start the music for left channel of yourChannel Mixing DM1835X Multiple Channel Mixing Beatkeeper Troubleshooting T4 Either the BPM display is blank, or it is noticeably offT9 The beat tracking suddenly gets off track DM1835X Rear Panel Diagram DM1835X Instructions for Connection and Diagram Specifications Signal to Noise Ratios vs. maximum outputP U T S T P U T SBlock Diagram Equipment Transport