DM2000X
CROSSFADER SECTION
7.The Replaceable Crossfader achieves clean segues between the two selected input channels. "Hard left" selects Channel 2. "Hard right" selects the Channel 3. With the crossfader centered both channels are live. Use the crossfader for fast and seamless segues from one selected channel to the other.
N o t e : The crossfader is user replaceable in case of failure. Simply unscrew the two large screws which hold it in place, lift it out and disconnect it’s cable.
8.The Crossfader Control toggle allows the DJ either reverse the direction of the crossfader or turn it off. By reversing direction Channel 3 will be on the left and Channel 2 will be on the right.
9.Transform Buttons are for quickly reversing the crossfader direction in order to create various special effects.
10.Beat indicator lights show peaks in the music that usually represent a strong drum beat. You can use these to help you try and match up beat mixes.
MASTER/BOOTH OUTPUT SECTION
11.The Stereo Master Fader controls the overall output level.
12.The Booth Level controls speaker volume for a remote zone or booth monitors. If you do not use booth monitors the output can feed a tape deck, another amplifier, another mixer or a satellite speaker system. Note: This can also be used to supply line level audio to a lighting controller or to lights that are sound activated.
CONTRACTOR'S NOTE: Booth Level provides zone control in installations where there are two separate rooms, or a bar and dance floor, for example. Remote zone volume should be controlled from the D M 2 0 0 0 X.
13.Stereo Output Level Indicator. This fast, accurate stereo meter tracks the output level. It's OK to be occasionally "in the red" as long as +5dB or +8dB
aren'constantlyt lit. Set the crossover, equalizer and power amp inputs to avoid distortion at each step in the audio chain. Proper attention to the meter results in the punchiest possible sound without audible distortion.
This meter is also used to monitor the PFL/CUE section. When a PFL LED is lit the display indicates this channel, when the MASTER LED is lit then the Master output is shown.
CUE SECTION
14.The C U E section includes the Program Mix (PGM) control, the Headphone Volume control and the Headphone Connector located on the front of the unit. Connect headphones with a standard 1/4" stereo plug. The P F L audio is sent to the headphone amp using the PFL Assign Pushbutton and the PGM Mix control. The Program Mix controls the amount of program audio in the headphones so that beats can be matched exactly and segues are smooth when a song is cued.
MIC SECTION
15.The MIC Connector is located on the front panel of the unit and is controlled through an input on Channel 1.
16.12V BNC Connector allows a 12 volt gooseneck lamp to be connected directly to the mixer. This light is readily available from your Numark dealer.
17.Power Switch and Power - On LED.
Numark - The Proven Leader in DJ Technology
©1997 Numark Industries | 7 | http://www.numark.com |