Numark Industries DM 1885X owner manual DM1885X Rear Panel Diagram

Page 12

DM 1885X

DM1885X REAR PANEL DIAGRAM...

 

11

 

 

 

 

 

 

8

 

8

12

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

10

1

 

 

 

 

 

 

 

 

 

6

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

2

3 5

7

7

7

9

7

9

7

9

1.The Balanced Main Outputs are low-impedance XLR type connectors controlled by the Master fader.

2.The Stereo Main Outputs are low-impedance RCA connectors controlled by the Master fader.

3.The Tape Outputs are low-impedance unbalanced RCA jacks which output the program mix and allow you to connect any recording device.

4.The Stereo Zone Outputs are low-impedance unbalanced RCA jacks controlled by the Zone Level controls.

5.The S e n d can be attached to an external effects processor such as a sampler.

6.Mic is the mic input for the Mic Channel and Channel 4.

7.Channels 1-5 Line Inputs are unbalanced RCA jacks. The Line Input is selected with the toggle switch on the front panel. You can connect stereo audio from HiFi VCRs, cassette and reel-to-reel tape decks, DAT machines, CD players, laser discs, tuners, even synthesizers or other mixing consoles.

N O T E : Plug mono audio sources into both Left and Right inputs using a “Y” cable connector.

8.Line/Phono Input switch. Use this to allow line level equipment to be plugged into your phono inputs giving you a total of 8 line input options.

9.Phono Inputs on Channels 1, 2 and 3 use unbalanced RCA jacks. Your input signal is fed directly to the D M 1 8 8 5 X's high-quality RIAA phono preamplifiers so use this position only for moving magnet cartridges. Line level sources will overload the sensitive phono preamps and will sound very bad, so always be sure to toggle the line/phono switch over to line before connection of line sources.

10.AC Cord. See safety precautions on page 3 for proper treatment of the power cord.

11.Voltage Selector. Set this for the appropriate voltage in your area

12.GND is the grounding lug for turntables 1, 2 and 3 (phono inputs on Channels 1, 2 and 3). Always use this connection (your turntable cable should have a grounding wire).

Numark - The Proven Leader in DJ Technology

©1997 Numark Industries

12

http://www.numark.com

Image 12
Contents DM 1885X Stereo Mixer DM1885X Safety Instructions Index Features CongratulationsNumark The Proven Leader in DJ Technology System Precautions Important InformationDM1885X Front Panel Diagram DM1885X Digital Sampler Section About Stuttering DM1885X Rear Panel Diagram DM1885X Instructions for Connection and Diagram Specifications P U T S M P L E RBlock Diagram Equipment Transport