Pioneer SX-A6MK2-K operating instructions Additional information Chapter, Troubleshooting

Page 21

Additional information

Chapter 7:

Additional information

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

•If the unit does not operate normally due to external effects such as static electricity disconnect the power plug from the outlet and insert again to return to normal operating conditions.

Problem

Remedy

The power does not turn on.

• Disconnect the power plug from the outlet, and insert again.

 

• Make sure there are no loose strands of speaker wire touching the rear

 

panel. This could cause the receiver to shut off automatically.

 

• If you’re trying to switch on using the remote control, make sure the

 

front panel POWER button is switched on first.

 

• If the power shuts off automatically, take the unit to your nearest

 

Pioneer authorized service center or your dealer for servicing.

 

 

No sound is output when a

• Make sure the component is connected correctly (refer to Connecting

function is selected.

up on page 8).

 

• Press MUTE on the remote control to turn muting off.

 

 

Considerable noise in radio

• Connect the antenna (page 9) and adjust the position for best reception.

broadcasts.

• Route any loose cables away from the antenna terminals and wires.

 

• Fully extend the FM wire antenna, position for best reception, and

 

secure to a wall (or connect an outdoor FM antenna).

 

• Connect an additional internal or external AM antenna (page 9).

 

• Turn off equipment causing interference or move it away from the

 

receiver (or move antennas farther away from equipment causing noise).

 

 

Broadcast stations cannot be

• Connect an outdoor antenna (refer to page 9).

selected automatically.

 

 

 

Noise during playback of a

• Move the cassette deck further from your receiver, until the noise

cassette deck.

disappears.

 

 

Can’t operate the remote

• Replace the battery (refer to page 7).

control.

• Operate within 7 m (23 ft.), 30° of the remote sensor on the front panel

 

(refer to page 13).

 

• Remove the obstacle or operate from another position.

 

• Avoid exposing the remote sensor on the front panel to direct light.

 

 

07

English

21

En

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Operating Instructions Mode d’emploi Operating Environment POWER-CORD Caution Ventilation Caution   We Want You Listening For a LifetimeContents Before you start FeaturesBefore you start Chapter What’s in the boxInstalling the receiver Before you start Inserting the batteryConnecting up Chapter Connecting upConnecting audio components Making cable connectionsConnecting antennas Connecting upUsing external antennas To improve FM receptionConnecting up Connecting the speakers Bare wire connectionsPlugging Controls and displays Power OFF ON1Controls and displays Chapter Front panelControls and displays Remote control  TUNE/PRESET /ENTERDimmer Using the remote control Controls and displaysDisplay Listening to your system Using the tuner Chapter Using the tunerSaving station presets Naming station presetsListening to station presets Using the tunerPress / to select the station preset you want Press repeatedly to cycle through classes A, B and COther connections Connecting your XM Radio receiverOther connections Chapter Listening to Satellite RadioSaving channel presets Other connectionsListening to XM Radio Operating other Pioneer components with this unit’s sensor Other connections Connecting an IR receiverComponent PioneerSwitching components on and off using the 12 volt trigger Troubleshooting Additional informationAdditional information Chapter Additional information SpecificationsXM radio messages Amplifier sectionAccessories Cleaning the unitAudio section MiscellaneousMilieu de fonctionnement Avertissement Précaution DE VentilationTable des matières Préparatifs Chapitre PréparatifsCaractéristiques Contenu de la boîte01 Préparatifs Insertion de la pile Installation de l’ampli-tunerRaccordement Chapitre RaccordementRaccordements des câbles Raccordement des composants audioConnecter les antennes RaccordementUtilisation des antennes externes Pour améliorer la réception FMBranchement Raccordement Raccordement des enceintesRaccordements avec fil dénudé Assurez-vous de raccorder l’enceinte de droiteCommandes et afficheur Commandes et afficheur ChapitrePanneau avant Commandes et afficheur Télécommande   TUNE/PRESET /ENTERMute Commandes et afficheur Utilisation de la télécommandeAfficheur Écoute de votre système Utilisation du syntoniseur Chapitre Utilisation du syntoniseurÉcoute de la radio Enregistrement des stations prérégléesÉcoute de stations préréglées Utilisation du syntoniseurAutres raccordements Chapitre Autres raccordementsÉcoute de la radio par satellite Raccordement de votre ampli-tuner de radio XMAutres raccordements Écoute de la radio XMEnregistrement des canaux préréglés Composant Autres raccordements Raccordement d’un récepteur IRAutre que Raccordez la prise IR in d’un autreSpeaker R Informations supplémentaires Informations supplémentaires ChapitreGuide de dépannage Spécifications Informations supplémentairesMessages de radio XM Section amplificateurNettoyage de l’unité AccessoiresSection audio DiversPioneer Corporation
Related manuals
Manual 2 pages 19.88 Kb

SX-A6MK2-K specifications

The Pioneer SX-A6MK2-K is a sophisticated stereo receiver that stands at the intersection of advanced technology and passionate audio performance. Designed to cater to audiophiles and casual listeners alike, it offers a blend of classic design and modern conveniences.

At the heart of the SX-A6MK2-K is its powerful amplification system, delivering 100 watts per channel into 8 ohms, ensuring that even the most demanding speakers can perform optimally. This receiver employs a high-quality discrete amplifier design, which contributes to its clarity and dynamic range, allowing music to be reproduced with exceptional detail and precision. Audiophiles will appreciate the low distortion rates and the ability to handle transient peaks without compromising audio integrity.

One of the standout features of the SX-A6MK2-K is its extensive connectivity options. It includes multiple HDMI inputs, allowing for seamless integration with modern digital sources such as Blu-ray players, gaming consoles, and streaming devices. The receiver supports 4K video pass-through, making it an ideal hub for home theater systems. In addition to HDMI, it offers various analog and digital inputs, ensuring compatibility with older audio equipment.

Pioneer has incorporated several advanced technologies into the SX-A6MK2-K to enhance user experience. The receiver features an Automatic MCACC (Multi-Channel Acoustic Calibration System), which intelligently analyzes your room’s acoustics and optimizes sound performance accordingly. This technology allows users to achieve a tailored listening environment, making setup simpler and more effective.

The user interface of the SX-A6MK2-K is intuitive, featuring a clear LCD display and easy-to-navigate menus. In addition, the included remote control provides convenient access to all functionalities from the comfort of your seat. Built-in Bluetooth connectivity allows users to stream music wirelessly from their smartphones or tablets, making it easier than ever to enjoy their favorite tracks.

For those who appreciate vinyl, the SX-A6MK2-K comes equipped with a dedicated phono input, ensuring that your records sound lush and authentic. With its solid build quality and aesthetic appeal, this receiver is not only a functional audio component but also a stylish addition to your home decor.

In summary, the Pioneer SX-A6MK2-K is a remarkable stereo receiver that combines power, versatility, and advanced audio technology. With its array of features, it stands out as a premier choice for anyone looking to elevate their listening experience, whether for music, movies, or gaming.
Top Page Image Contents