Numark Industries owner manual DM1001X/DM1002X Face Panel Diagram, Installation and Operation

If this is your first mixer, please read this entire manual before you begin operation. If you are an experienced DJ we highly recommend reading the manual so you may fully appreciate this newer technology. This mixer can be 10” rack-mounted or used as a free-standing unit. Keep in mind that there are a few features you may never have seen before in a mixer of this type that you will need to read about.

INSTALLATION AND OPERATION

Study the Connections Diagram on page 13. First, connect all stereo input sources. Next connect your microphone(s) and monitor headphones. Make sure all faders are at "zero" and the unit is off. Finally, connect the stereo outputs to the power amplifier(s) and/or audio sources. Plug the mixer into AC power. Now you are ready to switch it on.

CHANNEL FEATURES

1.Channel Input Toggle Switches select which source will be active on that channel based on what you have connected to the rear panel input section.

2.The Input Faders are low-noise, low-impedance, high-quality, smooth Alps™ faders. These control individual source levels in the mix.

3.Treble, Middle, and Bass Controls are for setting appropriate equalized levels for the music you are playing. When turned all the way left they “CUT” the signal by -30dB for special effects mixing.

4.Gain Controls are for accurately matching audio input levels of the channels.

5.Microphone Controls are used to adjust input level and equalization level for your mic input. The talkover feature will bring down the level of the music while keeping the mic level up. This allows you to talk over the music.

6.Microphone Jack for a 1/4” Microphone connector.

7.KILL buttons (DM1002X only) are for instantly eliminating the chosen frequency area. This way you can mix the bass of one song with the treble and middle of another.

CROSSFADER SECTION

8.The Replaceable Crossfader achieves clean segues between the two selected input channels. "Hard left" selects Channel 1. "Hard right" selects the Channel 2. With the crossfader centered both channels are live. Use the crossfader for fast and seamless segues from one selected channel to the other.

N o t e : The crossfader is user replaceable in case of failure. Simply unscrew the two large screws which hold it in place, lift it out and disconnect it’s cable. Re-attach the new crossfader and screw the mounting plate back onto the unit - you’re back in business!

9.The Crossfader Control toggle allows the DJ to reverse the direction of the crossfader or turn it off. By reversing direction Channel 2 will be on the left and Channel 1 will be on the right.

10.Transform Buttons are for quickly reversing the crossfader direction in order to create various special effects.