Features and Specification, Users Guide

FEATURES AND SPECIFICATION

1.	Frequency Range: VHF 170~250 MHZ.
2.	Frequency Stability	0.005% quartz oscillation controlled.

3.Modulation(Max): 30KHZ.

4.Frequency Response:50Hz~18KHz 3dB.

5.Hum & Noise:96dB min.

6.Dynamic Range:100dB min.

7.Distortion:less than 1%.

1.Antenna:built-in with noise terminator circuit.

2.Battery:DC9V.

3.Current Consumption:30mA.

4.Power Output:20mW

5.Spurious Emission:45dB min.

1.Quartz controlled fixed frequency receiving mode. 2.Sensitivity: 10dB/uV(S/N 60dB).

3.Image and Spurious Rejection: min 80dB.

4.Output: unbalanced 0.15V 600 .

5.Receiver System: single channel non-diversity.

6.Power Source: DC 12V.

7.Dimensions: (H)220*(W)124*(D)32(MM).

	USERS GUIDE
Users Guide
1	Insert adapter DC plug into receiver DC input jack, insert the other AC plug
	into AC power supply outlet(According to the sign on the back side).
2	Sound Signal Output Jack: Insert one end of the cable connector plug into
	signal output jack at the back of the receiver and the other end of the plug
	into KTV or amplifier MIC-IN jack.
3	Push on receiver	s power switch, if power LED indicator on front panel
	lights, this indicates that receiver works normally.
4	Insert attached 9V battery into wireless microphone's battery compartment
	(pay attention to the positive and negative pole), and then close the cover.
5	Turn on microphone power switch, LED indicator will flash once then off ,
	it indicates that microphone is ready to use.
6	At this time receiver's RF LED indicator will light. Adjust volume control
	to make receiver	s volume to be in normal working state. Finish test of

wireless microphone.