AKG Acoustics WMS 300 manual Architects and Engineers Specifications, Accessories RMU2A

Page 3

Architects and Engineers Specifications

The wireless microphone system shall operate over the UHF frequency range from 766 to 805 MHz range, with transmitter power not exceeding 10 milliwatts. Both handheld and bodypack type transmitters shall be provided. The bodypack transmitter shall accommodate both microphone and line level inputs. The transmitters shall operate with a companding system that is complemented by the receiver, providing an A-weighted system dynamic range in excess of 100 dB. The transmitters shall indicate input overload and low battery power. Handheld transmitters shall have a maximum diameter of 2.125 in. (53 mm) and a length, including antenna, no greater that 11.125 in. (282 mm). The receiver shall operate on the true diversity principle, and that action shall be inaudible as such. Adjacent channel

isolation shall be at least 60 dB, and total harmonic distortion at 1 kHz for rated deviation shall be no greater than 0.8%. The receiver shall provide for a manual squelch adjustment for optimum system operation. An output level adjustment shall be provided, and there shall be both balanced XLR-M output and unbalanced 0.25 in. (6.5 mm) jack.

The wireless microphone system shall incorporate factory optimized sets of both sending and receiving frequency modules that are built into both transmitters and receivers. Each frequency set shall comprise a 20 MHz UHF band and offer at least 16 discrete operating frequencies within that band. The wireless microphone system shall be the AKG Acoustics Model WMS 300.

Graphical Data

 

 

 

 

 

Accessories: RMU2A

2-Unit rack mount mainframe with passive splitter

 

RMU2

1-Unit rack mount mainframe

 

P300

System antenna splitter

 

RA300B

Remote antenna for antenna splitter

 

 

 

 

AKG is constantly improving and modifying its products, therefore, specifications are subject to change without notice.

Limited Warranty

Valid only in the United States. AKG Acoustics warrants AKG products against defects in material or workmanship for a period of two years from the date of original purchase for use, and agrees to repair or, at our option, replace any defective unit without charge for either parts or labor. Important: This warranty does not cover damage resulting from accident, misuse or abuse, lack of reasonable care, the affixing of any attachment not provided with the product, loss of parts or connecting the product to any but the specified receptacles. This warranty is void unless service or repairs are performed by an authorized service center. No responsibility is assumed for any special, incidental

or consequential damages. However, the limitation of any right or remedy shall not be effective where such is prohibited or restricted by law. Simply take or ship your AKG product prepaid to our service department. Be sure to include your sales slip as proof of purchase date. (We will not repair transit damage under the no-charge terms of this warranty.) Note: No other warranty, written or oral is authorized by AKG Acoustics, Inc. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages or limitation on how long an implied warranty lasts, so the above exclusions and limitation may not apply to you.

Microphones · Headphones · Wireless Microphones · Wireless Headphones · Headsets · Electroacoustical Components

AKG Acoustics GmbH

Lemböckgasse 21–25, P.O.B. 158, A-1230 Vienna/AUSTRIA

Tel: (43 1) 86 654-0*, Fax: (43 1) 86 654-516

Internet: http://www.akg.com

AKG Acoustics; A Division of Harman Pro Germany Bodenseestraße 228, D-81243 München/GERMANY Tel: (089) 87 16-0, Fax: (089) 87 16-200

Arbiter Pro Audio

Wilberforce Road, London NW9 6AX/ENGLAND Tel: (0181) 202 1199, Fax: (0181) 202 7076

AKG ACOUSTICS, U.S.

914 Airpark Center Drive

Nashville, TN 37217, U.S.A.

Tel: (615) 620-3800, Fax: (615) 620-3875

Studer Japan Ltd.

2-43-7, Uehara, Shibuya-ku, Tokyo 151-0064/JAPAN Tel: (813) 3465-2211, Fax: (813) 3465-2214

Erikson Pro Audio

620 McCaffrey, St-Laurent, Quebec, H4T 1N1, CANADA Tel: (514) 738-3000, Fax: (514) 737-5069

Internet: www.jam-ind.com/eriksonpro

Specifications subject to change without notice.

DS-WMS 300

Image 3
Contents Description Microphone System FeaturesSpecifications PT 300 Bodypack Specifications SR 300 ReceiverSpecifications WT 300 Handheld Accessories RMU2A Architects and Engineers Specifications