Audio-Technica ATW-701/H, ATW-702 TenTips to Obtain the Best Results, Receiver, UniPak Body-Pack

Page 8

 

TenTips to Obtain the Best Results

1.

Use only fresh alkaline batteries. Do not use “general

8.

If the AF Level control of the receiver is set too high, it

 

purpose” (carbon-zinc) batteries.

 

may over-drive the input of the mixer or clip the output of

2.

Position the receiver so that it has the fewest possible

 

the receiver, causing distortion. Conversely, if the receiver

 

output is set too low, the overall signal-to-noise ratio of

 

obstructions between it and the normal location of the

 

the system may be reduced. Adjust the output level of

 

transmitter. Line-of-sight is best.

 

the receiver so the highest sound pressure level going

3.

The transmitter and the receiver must be set to the same

 

into the microphone (or the loudest instrument playing

 

level) causes no input overload in the mixer, and yet

 

frequency. Set or change transmitter frequency only

 

 

 

permits the mixer level controls to operate in their

 

when its power is turned off.

 

 

 

“normal” range (not set too high or too low). This

 

 

 

4.

The transmitter and the receiver should be as close

 

provides the optimum signal-to-noise for the entire system.

 

 

 

together as conveniently possible, but no less than six

9.

In the UniPak® transmitter, the “Mic” or “Inst” input

 

feet (2 m.).

 

control not in use should be set to minimum.

 

 

 

5.

Yellow LED indicates the channel is set to service position

10.

Turn the transmitter off when not in use. Remove the

 

(0 or 9); please select a valid operating channel (1-8).

 

 

battery if the transmitter is not to be used for a period of

 

 

 

6.

The receiver antennas should be kept away from any

 

time. Unplug the receiver from the AC outlet when the

 

system is not in use.

 

metal.

 

 

 

 

7.

A receiver cannot receive signals from two transmitters

 

 

 

at the same time.

 

 

 

 

 

 

For future reference, please record your system information here (the serial numbers appear inside the battery compartment of each transmitter, and on the bottom of each receiver):

Receiver

ATW-R700

S/N

UniPak® Body-Pack

ATW-T701

S/N

Transmitter

 

 

Handheld Dynamic

ATW-T702

S/N

Microphone Transmitter

Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224 330/686-2600 www.audio-technica.com

P51836-02 ©2011 Audio-Technica U.S., Inc. Printed in U.S.A.

Image 8
Contents Series Professional UHF Wireless Systems Professional UHF Wireless Systems IntroductionReceiver Installation Receiver Controls and FunctionsTransmitter Setup, Controls and Functions Battery SelectionSystem Operation Return the screwdriver to its storage clip when not in use RF InterferenceSeries Frequency Channel Plan Specifications†Series UHF Operating Frequencies TenTips to Obtain the Best Results ReceiverUniPak Body-Pack Transmitter Handheld Dynamic
Related manuals
Manual 65 pages 39.91 Kb