Pioneer VSX-45TX When youre done use the 5∞ Buttons to select Exit, Select Exit and press Enter

6-7,

9,10

SETUP

S0URCE	TV	SYSTEM RECEIVER
		OFF
DVD/LD	TV/SAT	VCR1/	TV CONT
		DVR
MULTI CONTROL
VCR2	VIDEO	CD		MULTI
			OPERATION
CD-R/	MD/	TUNER	RECEIVER
TAPE1	TAPE2
DIMMER	LOUDNESS	TONE	EFFECT/CH SEL
1	2	3		4
SIGNAL SEL	DNR	BASS/TREBLE	+
5	6	7	–	8
VIDEO SEL	HI-BIT	+10		DISC
9	0		ENTER
		DIRECT ACCESS SEARCH MODE
SYSTEM SETUP				GUIDE
MENU			TOP MENU
TUNER EDIT				TRACK
	ENTER
				EXIT
AUDIO			RETURN
MPX	DTV ON/OFF		DISP MODE
¶		8	SUB TITLE
TUNING –	BAND		TUNING +

1 3 ¡

STATION –	DTV MENU CLASS		STATION +
4		7	¢
CHANNEL–			CHANNEL+
	TV INPUT	INPUT
	TV CONTROL
TV VOL		MIDNIGHT	VOLUME
	TV CH
		MULTI CH
		INPUT
MOVIE	MUSIC	ACOUSTIC	MUTE
		EQ
MODE
		SURROUND	REMOTE
			SETUP
STEREO/	ENTER	SB CH
DIRECT		MODE

Î

Remote Control of Other Components

5While LEARN continues to flash, point the two remote controls toward each other. Press the button on the other remote control corresponding to the operation you want to program.

	1 3 – 4 7 –	¶ 8 –	– + 9 0	5 6 7	1 2 3	2-8 inches
Î	¡ + ¢ +	+	+	8	4

After the process is complete and the command has been learned, OK will appear in the remote control display. If NG (no good) appears, it means that for some reason the command was not learned. In this case, repeat steps 4 and 5.

CONTINUE? appears in the remote's display. If SELECT KEY is flashing go back to step 4.

6If you want to program in more commands use the 5∞ buttons to

select YES. Press ENTER.

Repeat steps 4 and 5 to teach the remote control of the VSX-45TX all the commands from the other remote control.

Buttons that are able to learn new commands

memo • If FULL appears in step 5 it means that there isn't enough capacity to learn this command. If you want to clear other buttons to make room for this one follow the procedure on page

87.

•If there isn't enough capacity, an in- correct signal has been sent or, in some cases, the command from an- other remote control simply cannot be learned, NG (no good) will appear in the display in step 5.

•In some NG cases the remotes just need to be moved closer together or farther apart.

7If you want to program in commands for another MULTI CONTROL button use the 5∞ buttons to select NO. Press ENTER.

8Repeat the process from step 2 for

all of your components.

Start again to program other components in this manner.

9When you're done use the 5∞

buttons to select EXIT.

You will return to the REMOTE SETUP menu.

10 Select EXIT and press ENTER.

BASIC

65