Pioneer VSX-43TX operating instructions Remote Control of Other Components, LED lights continously

Remote Control of Other Components

Setting Up the Remote Control to Control Other Components

In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV, DVD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and buttons, you only need to use one remote control. If your component(s) are listed in the remote control's memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote to learn additional operations, you can use the learning mode to input the information from the remote controls supplied with your other components.

Recalling Settings Stored in the Remote Control

The following steps show you how to recall the setting stored in the remote control. Once a setting is recalled and the component assigned, you can use this remote to easily operate the component.

memo • To exit from the remote control setup mode at any time, press REMOTE SETUP.

• See "Using Remote Control with Other Components" on pages 61–62 to operate your other components.

• The TUNER button cannot be assigned.

2

3

RECEIVER MULTI		SYSTEM	SOURCE
OPERATION		OFF
	MULTI CONTROL
DVD/LD	TV/SAT	VCR/DVR	TV CONT
VCR 2	C D	TUNER	RECEIVER
MOVIE	MUSIC	ACOUSTIC	INPUT
		EQ
SURROUND		SB CH	MULTI CH
MODE		MODE	INPUT
STEREO/	ENTER	MIDNIGHT
DIRECT
			MUTE
	MASTER
	VOLUME
MENU TUNER EDIT			TOP MENU
SYSTEM	TUNE		GUIDE
SETUP
ST		ST
	ENTER
AUDIO			RETURN
	TUNE
CHANNEL−	DTV ON/OFF BAND		CHANNEL+
	D.ACCESS	MPX	CLASS
DIMMER	LOUDNESS	TONE	EFFECT/CH SEL
			ENTER
SIGNAL SEL	DNR	BASS/TREBLE	DISC

VIDEO SEL	HI-BIT	+	+ 10
		−
TV CONTROL			SUB TITLE
INPUT	CHANNEL VOLUME		REMOTE
SELECT
			SETUP

RECEIVER

LED

1

1

1While holding down the REMOTE SETUP button press to select the

preset recall setup mode.

The LED begins to blink.

To cancel the preset recall setup mode press REMOTE SETUP.

2Press the MULTI CONTROL button for the component you want to

control.

The LED lights continously.

3Point the remote toward the component to be controlled, enter the 4 digit setup code (see pages 93-

94 for codes).

The LED blinks.

After a code has been input the power of the compo- nent being input will turn on or off.

The remote will return to the previous mode after thirty seconds of inactivity.

The power of the component being input will only turn on or off if that component is able to be turned on directly by remote control.

Repeat steps 2 through 3 to assign preset codes for as many components as necessary.

If you can't get your component to respond to any of the codes you can still program the component into the remote control using the procedure in the next section.

4Press the REMOTE SETUP button to

exit the preset recall setup mode.

The remote control and receiver return to their previous operation modes.

BASIC

59