MM-2400 Controls, Fader Replacement, Specifications

(MM-2400) CONTROLS:

32 ECHO SECTION:

An echo effect may be applied to the PGM, or MIC 1 & MIC 2 signals by switching the ECHO ASSIGN switch from MIC 1-2on the LEFT, to OFF in the MIDDLE, to MASTER on the RIGHT & vice versa. When using ECHO, you may adjust the effect of the ECHO by using the rotary REPEAT, DELAY, and ECHO VOLUME controls. To turn the ECHO ASSIGN OFF or lower the ECHO VOLUME.

33 SOUND EFFECTS SECTION:

Six different sound effects (APPLAUSE, SCREAM, COPTER, SCRATCH, H2O & GLASS) may be added to your mix by pressing the SOUND EFFECTS CONTROL BUTTONS. The volume of the effects can be adjusted using the rotary EFX VOLUME located above the APPLAUSE effect button. The pitch of the effects can be increased or decreased using the rotary SPEED CONTROL located above the SCRATCH effect button.

MM-1800/2400

FADER REPLACEMENT:

1.UNSCREW THE FADER (B) SCREWS. DO NOT TOUCH INSIDE SCREWS (C) CAREFULLY REMOVE OLD CROSS FADER AND UNPLUG CABLE (D)

2.PLUG IN THE NEW CROSS

FADER INTO CABLE (D) AND

PLACE BACK INTO MIXER.

3.SCREW THE CROSS FADER TO MIXER WITH THE FADER PLATE SCREWS (B)

4.REPLACE THE FACE OF THE MIXER AND SCREW THE FOUR

SCREWS BACK IN AND REPLACE THE FADER KNOBS.

SPECIFICATIONS:

INPUTS:

Phono:	3 mV, 47 KOhm
Line:	150 mV, 27 KOhm
MIC 1, 2, & 3:	1.5 mV, 2 K Ohm Balanced
Bass:	± 12dB
High:	± 12dB

OUTPUTS:

Amp/Booth:	0 dB 1 V, 400 Ohm
Max:	20 V Peak-to-Peak
Rec	150 mV, 5 KOhm
Zone	0 dB 1 V 400 Ohm
Balanced	6 dB 2 V 400 Ohm

GENERAL:

Frequency Response:	20 Hz - 20 KHz +/- 2 dB
Distortion:	0.02%
S/N Ratio:	Better Than 80 dB
Talkover Attenuation:	-16 dB
Headphone Impedance:	16 Ohm
Power Source:	115/230 V, 60/50 Hz, 20 W
Unit Dimensions:	W 19" x H 4" x D 9.1"
..................................................................	(482.6 x 100.6 x 231.2 mm)
Weight:	10.34 lbs (4.7 kg)

SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATION

FOR IMPROVEMENT