IPod/iPhone Dock, CD Player, DVD Player, Setup

6.3DVD/CD/Media Player

NOTE: When turned fully counter-clockwise until it clicks, the MP3 / Disc Volume control also turns off the power to the DVD/CD/Media Player. To turn the power on, turn the knob above the minimum setting.

CD Player

1.Insert a standard CD into the slot. When the CD player is on without a disc inside, the LCD display will show “LOAD.” Once a CD is inserted into the slot, the LCD display will show “READING DISC.”

2.Press the Play button to start playing the audio track. Press it again to pause playing. Press Stop to stop playing; it will resume play at the place it has been stopped. Press Stop again to revert to the beginning of the CD.

3.Press the Eject button to remove the CD from the slot. If the CD is not removed, the CD will be pulled in automatically after 30 seconds.

4.Press the Fast Forward and Fast Reverse buttons to choose the desired track. To fast forward or rewind through a song, press these buttons continuously and press Stop at the desired point.

5.To set the Audio, connect the PA419 to a display screen and press the Audio button on the remote control. The audio may be set to Mono left, right, mix mono, or stereo.

DVD Player

1.Connect the Video Output (RCA) to the Video input of the TV or monitor.

2.Power on both units. Insert a standard DVD into the PA419 slot.

3.Once the DVD is read, the menu screen will appear on the display screen.

4.Press the Play button to start the DVD, or navigate through the menu screen using the arrow buttons.

5.If desired, for additional volume, connect the Audio Outputs using RCA cables to the audio input of the TV or additional PA / sound system.

Setup

When pressing the SETUP button on the remote control, a menu appears on the TV screen: System Setup, Language Setup, Audio Setup, and Video Setup.

•SYSTEM SETUP: The System Setup screen allows the TV System (NTSC/PAL), Screen Saver, Video (S-Video), TV Type (screen ratio), Password, and Rating Level to be set. Also, this menu allows resetting the DVD Player to factory default settings.

califone.com

•LANGUAGE SETUP: The Language Setup screen allows the OSD Language to be customized.

•AUDIO SETUP: The Audio Setup screen allows the EQ and Stereo/Mono setting to be customized.

•VIDEO SETUP: The Video Setup screen allows customization of the Sharpness, Brightness, Contrast, Hue, and Saturation.

•To exit the Setup menu, press the SETUP button again.

USB Media Player

1.Connect the PA419 Video Output to a display screen.

2.Place the USB key into the USB slot. Press the USB / DISC button on the remote control or front panel to enter USB mode.

3.Press the Program button on the remote control to view all files.

4.Scroll through the different media types and then using the arrow buttons, scroll through the different files and press the Enter button to select a file.

5.Press File Forward to navigate to the next file, and then use Skip Forward to select the track to play.

6.4iPod/iPhone Dock

1.Connect the iPod/iPhone to the dock located on the top of the PA419.

2.Operate the iPod/iPhone using the buttons on the bottom section of the remote control or the dock to play audio or video files.

3.Adjust the volume using the Vol+/- buttons on the remote control or the buttons on the iPod/iPhone dock.

6.5UHF Receiver

1.Set the PA419 UHF Receiver to same frequency as the transmitting microphone by turning the UHF Receiver knob to the desired frequency.

2.The Power LED will light up red when the UHF Receiver is turned on.

3.When a transmitter is connected, the RF A/B LED will light green.

4.The AF LED will turn green when sound is being transmitted through the microphone to the PA419.

5.Slowly increase the volume to the desired level. Note that the master volume of the PA419 may also need to be adjusted.

califone.com