American DJ Flight-Moon Flight Moon Master/Slave Settings, Flight Moon Optional Foot Controller

Flight Moon™ Master/Slave Settings

This chart details the Master/Slave dip switch setting for Master/Slave configuration for four units. Use these dip switch setting when you will be using two or more fixtures in a Master/Slave configuration. The “Master - Head 1” settings should only be used once.

Flight Moon™	Optional Foot Controller Cont.
	13

ON

1 2 3 4 5 6 7 8 9 10

Master - Head 1

ON

1 2 3 4 5 6 7 8 9 10

Head 3

ON

1 2 3 4 5 6 7 8 9 10

Head 2

ON

1 2 3 4 5 6 7 8 9 10

Head 4

14 15 16 17

13. Output Jack - This is a stereo output jack used to link the foot con-

troller to the main unit. Be sure only to use a stereo to stereo 1/4” male

plug for proper functionality.

Flight Moon™ Focusing

1.To focus a Flight Moon,™ it is best to first turn down the music sensitivity knob to its minimum position.

2.Loosen the two thumb screws on the front of the unit that hold the lens in place.

3.Adjust the focus by manually sliding the lens up and down.

4.Tighten the thumb screw after you achieve your desired focus.

Flight Moon™ Optional Foot Controller

The FlightMoon/C™ controller may be purchased separately allowing you to control the main unit, and any others connected to it, while it is in sound-active or master/slave mode. You can set the unit to blackout, change colors, and change operating modes. If you have more than one unit, make sure the remote control is plugged into the first unit in the daisy chain. The remote control will not have any effect if the unit(s) is in DMX mode.

14. Effect Switch - This switch will dictate the functionality of the Func-

tion Switch (16). Holding down the switch for more than 1 second will

change the mode. Mode 1 is indicated by the green LED. When in

mode 2 the green LED is off.

15.LED Function Indictors - These green LEDs indicate current activ- ity.

16.Function Switch - This switch works in conjunction with the Effect Switch (14) to dictate the unit’s function. Holding down the switch for more than 2 seconds will change function. The remote can control 4 different operating function (2 in each mode) plus blackout.

MODE 1 (Effect LED On): Function 1 (LED On) - Tapping the

function switch slowly changes colors. Function 2 (LED off) - Tapping the function switch rapidly changes colors.

MODE 2 (Effect LED off): Function 1 (LED on) - Units will react quickly to an audio source.

Function 2 (LED off) - Unit will react slowly to an audio source

17.Blackout Switch - This button will blackout out the unit regardless of the current operation.

©American DJ® - www.americandj.com - Flight Moon™ Instruction Manual Page 15 ©American DJ® - www.americandj.com - Flight Moon™ Instruction Manual Page 16