American DJ Bar-T-Cue operation manual Introduction, Technical Specifications, DMX mode

American DJ R

Bar-T-Cue

OPERATION MANUAL

INTRODUCTION:

This model is used as either a 4CH. DMX chase controller or a DMX dimmer pack. It has two operating modes consisting of DMX and MASTER modes, which allows to receive and send DMX signals. In DMX mode, it features 4 channel individual DMX address setting. In MASTER mode, it is incorporated with 6 operating modes, MANUAL DIMMER, MANUAL PROGRAM, AUTO PROGRAM, HOLD SOUND, PROG SOUND and AUTO SOUND. In addition, multiple units can be connected to be used together, one as a DMX dimmer pack and the others as chase controllers. Also, STAND BY, FULL ON and PREHEAT functions are incorporated with this unit.

Before operating this unit, please read this manual thoroughly.This manual will guide you through all functions step by step.

TECHNICAL SPECIFICATIONS:

POWER INPUT	AC 120V~60Hz, 20A
CHANNEL OUTPUT	5A /CH., Total 20A max.
FUSE	F5A 250V 5x20mm
DIMENSIONS	1308x80x74mm
WEIGHT	4.0Kg
OPERATING CONDITIONS	TEMPERATURE: 0--50°C
	RELATIVE HUMIDITY: ≤ 85%

PRODUCT INSTRUCTION:

A. DMX mode

When the DMX indicator is on, this unit is used as a DMX dimmer pack.

1. BUTTONS 1, 2, 3 and 4

Press any one of these 4 buttons, corresponding indicator will blink, and the DMX address of corresponding channel will appear in DISPLAY screen. Press UP or DOWN button to select desired DMX address followed by pressing corresponding channel button, corresponding indicator is off indicating information of entry is confirmed. then the information in DISPLAYscreen returns to initial condition..

2. UP BUTTON

Press to increase the display value.

3. DOWN BUTTON

Press to decrease the display value.

4.F+ BUTTONS(Press F andbuttons at a time.)

Press to select L-- or R--.

NOTE: L-- refers to data information of CH.1,CH.2, CH.3 and CH.4 corresponding to 1, 2, 3 and 4 output. R-- refers to data information of CH.1, CH.2, CH.3 and CH.4 corresponding to 4, 3, 2 and 1 output.

5. F+D/S BUTTONS(Press F and D/S buttons at a time.) Press to select CRO or NOR.

NOTE: NOR refers to 0-100% dimming.

CRO denotes only FULL ON and STAND BY are available.When dimming level is greater than 50%,

FULL ON is activated, otherwise, STAND BY is effective.

6. F+MODE BUTTONS

This function is effective only in MASTER mode.

7. F+PRESET BUTTONS

Press to select available parameter information used with UP and DOWN buttons.

PARAMETER

F00-F99

P00-PFF

E00-E25

8. F+SIGNAL SELECT BUTTONS

FUNCTION

FADE TIME(0-10S)

DIMMER(0-100%)

PRESET MINIMUM DIMMING LEVEL(0-25%)

Press to select operating mode from DMX to MASTER mode, and the DISPLAY will show OUT.

24-004-0206

Rev 2.0