American DJ specifications Model Flash-2C, Power 110V/60Hz Weight 8 lbs

American DJ® User Instructions

Flash-2C™

4 CHANNEL FLASH TUBE CONTROLLER

POWER

		ZONE CONTROL
1	2	3	4	SYNC AUTO

FLASH MANUAL

MODE SELECT

PULSE CONTROL

SPEED RATE

AUDIO TRIGGER

Model: Flash-2C™

SPECIFICATIONS:

Power: 110V/60Hz

Weight: 8 lbs.

Size: 19” x 3.5” x 5”

Fuse: 15A

SET UP:

Link the Flash Tubes to the Flash-2C™ by inserting tube connectors into controller sockets on the back of unit. The maximum length to first Flash Tube™ is 10 ft, any more and you will have to use a Flash Buffer.

If you connect more than 30 Flash Tubes in any single line use a Flash Buffer™ to boost signal.

At the end of each line connect a Flash-Term™. If you don’t use one the Flash Tubes will work but not properly. Plug Flash-2C™ and any Flash Buffer™ into power.

Refer to Operating instructions for use.

Thank you for purchasing this

American DJ® product. For your convenience this products ready to be used, there is no assembly required.

Please read the following instructions before installing or using your new unit.

Operating Instructions:

The American DJ® Flash-2C, flash tube controller is ideal for mobile DJ’s and club use. One Flash-2C will control 4 expandable lines of Flash Tubes.

POWER- ON & OFF

1,2,3,4 - ON & OFF for individual lines. SYNC - All tube flash at the same time AUTO - Flashes line of tubes one by one SPEED knob - Controls speed of chase. RATE knob - Controls rate of pulse (ie. speed between triggering strobe) of the Flash Tubes. TRIGGER - starts a flash run when in manual mode MANUAL - allows you to TRIGGER flash manually. MODE SELECT - Choose 1 of 4 modes to chase in.

1.	Rebound
2.	Crossover
3.	Reverse
4.	Forward

Caution! Always use appropriate cables and

connectors. Remember to always replace with

same fuses. Always keep controllers dry. Don’t For service, contact your American DJ® dealer. exceed load and length limitations

American DJ® LOS ANGELES, CA. 90058 USA • www.americandj.com