Reflex Features, Reflex Warranty Registration

Reflex™

Features

•Two Independent Moving Heads

•Easy Lamp Replacement

•Compact High-Tech Case Design

•Built-In Hanging Yoke

•Internal Microphone

•Multi-Colored Beams

•3-Way Effects Switch - 3 Operating Modes

•Sound Active

•2 x LL-64610 12v/50w Lamps

Reflex™

Warranty Registration

The Reflex™ carries a one year (365 days) limited warranty. Please fill out the enclosed warranty card to validate your purchase. All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R.A.) number. The R.A. num- ber must be clearly written on the outside of the return package. A brief description of the problem as well as the R.A. number must also be written down on a piece of paper included in the shipping carton. If the unit is under warranty, you must provide a copy of your proof of purchase invoice. You may obtain a R.A. number by contacting our customer support team on our toll free customer support number. All packages returned to the service department not displaying a R.A. number on the outside of the package will be returned to the shipper.

Reflex™

Precautions

Safety Issues: This unit may blow a fuse if the maximum allotted load of 2 amps is reached. If the fuse needs replacement please refer to the fuse replacement instructions on page 5.

•To reduce the risk of electrical shock or fi re, do not expose this unit rain or moisture

•Do not spill water or other liquids into or on to your unit

•Do not attempt to operate this unit if the power cord has been frayed or broken

•Do not attempt to remove or break off the ground prong from the electrical cord. This prong is used to reduce the risk of electrical shock and fi re in case of an internal short

•This unit is intended for internal use only, use of this product out- doors voids all warranties written or implied.

Reflex™

General Instructions

Please carefully read and understand the instructions in this manual thoroughly before attempting to operate this unit. These instructions contain important safety information regarding the use and mainte- nance of this unit. Please keep this manual with the unit, for future reference.

Reflex™

Operation

Power Supply: Before plugging your unit in, be sure the source voltage in your area matches the required voltage for your American DJ® Refl ex™ before attempting operation.

General Operation: Just plug this light in, and watch it go. This fix- ture is designed to operate as a stand alone unit. It has been tested and the lamp has been installed at the factory there is no assembly necessary. The Reflex™ is ready to be plugged in, out of the box. There is no power switch, after plugging the unit in the unit will imme- diately begin to run to sound. Please note that tapping on the unit, or high pitched sounds may not trigger the unit, the unit is designed to react to low frequencies (bass). Also note that the music sensitiv- ity is preset at the factory and may not be changed or adjusted. The fashion the unit will operate will depended on the mode setting, see operating modes below.

Operating Modes: This unit comes with a 3-way multi-operating switch located on the bottom of the unit. The switch controls three different sound-active operating modes.

Switch in the "I" position: Mode 1 - In this mode the two internal dichroic colored glass dishes will rotate continuously regardless of an audio source. The two external reflecting mirrors will only react to an audio source via the units internal microphone.

Switch in the “O” position: Mode 2 - In this mode the two internal dichroic colored glass dishes will remain static regardless of an audio source. The two external reflecting mirrors will only react to an audio source via the units internal microphone.

Switch in the “II” position: Mode 3 - In this mode both the two internal dichroic colored glass dishes and the two external reflecting mirrors will only react to an audio source via the units internal microphone.