VERTI PRO II™ | Fuse & Lamp Replacement |
|
|
Caution: Always replace with the exact same type lamp and fuse, unless otherwise specified by an authorized American DJ® technician. Replacing with anything other than the specified part can damage the unit and will void the manufactures warranty.
Warning: If, after replacing the lamp or fuse either one continues to blow, STOP using the unit. Contact customer support for further instructions, you may have to return the unit for servicing. Continuing to use the unit may cause serious damage.
Fuse Replacement: Disconnect the unit’s main power supply. Insert a standard flat head screw driver in to the fuse holder housing. Turn the screwdriver in
Lamp Replacement: Caution! Never attempt to change the lamp while the fixture is plugged in. Always disconnect the main power and allow the unit ample time to cool before attempting to replace the lamp. Lamp replacement has been made simple by incorporating the use of a
1.Be sure to follow the proper handling procedures that deal with halogen lamps.
2.Remove the single thumb screw located in the front of the unit.
3.
4.Carefully remove the old lamp and discard it in the trash.
5.Replace the lamp with an exact match and reassemble.
Halogen Lamp Warning:
This fixture is fitted with a halogen lamp which is highly susceptible to damage if improperly han- dled. Never touch the lamp with your bare fingers as the oil from your hands will shorten lamp life. Also, never move the fixture until the lamp has had ample time to cool. Remember, lamps are not covered under warranty conditions.
VERTI PRO II™ | Trouble Shooting |
|
|
Trouble Shooting:
Listed below are a few common problems that you may encounter, with solutions.
No light output from the unit;
1.Be sure you have connected your unit into a standard 120V (or 220v depending on the models voltage requirements) wall outlet.
2.Be sure the external fuse has not blown. The fuse is located on the rear panel of the unit.
3.Remove the lamp cover and be sure the lamp is seated in its socket properly. Occasionally lamps become loose during shipping be sure the lamp is push in to its socket all the way. Remember not to touch the lamp with your bare fingers.
4.Be sure the fuse holder is completely and properly seated.
Unit does not respond to sound;
1.Low frequencies (bass) should cause the unit to react to sound. Tapping on the microphone, quiet or high pitched sounds may not activate the unit.
2.Be sure the SENSITIVITY KNOB (3) is not set to the maximum position.
VERTI PRO II™ | Cleaning |
|
|
Fixture Cleaning:
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses and mirror should be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates (I.e. smoke, fog residue, dust, dew). In heavy club use we recommend cleaning on a monthly basis. Periodic cleaning will ensure longevity, and crisp output.
1.Use normal glass cleaner and a soft cloth to wipe down the outside casing.
2.Use a brush to wipe down the cooling vents and fan grill.
3.Clean the external lens with glass cleaner and a soft cloth every 20 days.
4.Clean the internal lens with glass cleaner and a soft cloth every
5.Always be sure to dry all parts completely before plugging the unit back in.
©American DJ® - www.americandj.com - VERTI PRO II™ Instruction Manual Page 11 | ©American DJ® - www.americandj.com - VERTI PRO II™ Instruction Manual Page 12 |