CENTER DELAY Button (remote only) 36
The CENTER DELAY button works like the SURROUND DELAY but- ton above, except that it increases the delay the center channel speaker, if present. CENTER DELAY is only available in Dolby Digital surround mode. The CENTER DELAY button steps sequen- tially through five available settings (O, 1, 2, 3, 4, 5 ms).
NOTE: The CENTER DELAY setting is
You will get visual confirmation of your delay time setting on the VOLUME DISPLAY as you adjust the setting. The delay time setting also appears in the
DYNAMIC Button (remote only) 37
This button is used to reduce the dynamic range to accommodate program material that could tax your system or for
Press the button repeatedly to step through the four available set- tings: NONE (full dynamic range), 25% reduction, 50% reduction, and 75% reduction. While making the adjustment, the setting will appear in the VOLUME display. The setting is also shown in the
A
BACK/BALANCE CHECK (remote only) 41
The BACK button on the remote control is used during initial cali- bration of relative speaker volume levels. Generally, it is only used during initial setup of the system and not during normal operation.
To enter the BALANCE CHECK calibration, press and hold the BACK button for 2 seconds. The following screen will appear on your TV monitor, for adjusting the relative volume levels of the front, center, and rear speakers, along with the subwoofer.
BALANCE CHK |
|
|
L/F | CEN | R/F |
0dB | 0dB | 0dB |
S/L | SUB | S/R |
0dB | 0dB | 0dB |
RSP-975
will disappear after all six speakers have been highlighted and you may need to
While seated in the normal listening location, switch the test tone to the various speakers and listen to hear if any are noticeably louder or quieter than the front speakers. If so, adjust the quieter speakers volume levels up or down to match the louder speakers using the VOL UP/DOWN remote buttons, while the speaker you wish to adjust is highlighted. Continue switching among the speakers and adjusting until all of the speakers are approximately the same volume (or to suit your listening preference).
This setting will be memorized when you leave the menu and will become the
ENTER/OUTPUT BALANCE (remote only) 42
The ENTER button on the remote control has a similar function to the BALANCE CHECK calibration described above, except that its adjustments are temporary and apply only to the selected source input. As soon as you select a different source, the settings revert to the
NOTE: Although these adjustments can be made directly using the ENTER button, we strongly recommend that you only make these adjustments from the
RECALL Button 33
You can temporarily reset the OUTPUT BALANCE settings to 0dB for all speakers at any time by pressing the RECALL button on the remote control. The memorized
ON-SCREEN Button (remote only) 35
Push this button to turn on the
When the menu appears, the L/F speaker label will be flashing and you will hear a test tone coming from that speaker. You can select the other speakers by sequentially pressing the BACK button. The test tone will shift accordingly to the selected speaker. The menu
11