CONTROLS AND FUNCTIONS
TOP PANEL | 3 | 2 | 4 | 1 | 4 | 2 | 3 |
|
|
|
|
|
|
| |
13 |
|
|
|
|
|
| 9 |
|
|
|
|
|
|
| 10 |
|
|
|
|
|
|
| 11 |
|
|
|
|
|
|
| 12 |
5 |
|
|
|
|
|
| 5 |
|
|
|
|
|
|
| 6 |
|
|
|
|
|
|
| 7 |
|
|
|
|
|
|
| 8 |
qPOWER LED
The LED is lit when power is on.
wINPUT SELECT SWITCH
Used to select the input (LINE or PHONO ) to be sent to each PGM channel.
eTRIM CONTROL
Adjusts the input level of each channel.
rISOLATOR (HI,MID,LOW)
Cuts and boosts each frequency range. The level is flat when this knob is set at 12 o'clock.
tINPUT FADER
Used to adjust the input level of each program. Usually set at the
yINPUT LEVEL METER
The LED level meters indicate the input signal level of each PGM channel.
uCROSS FADER
When the input level of PGM1 and PGM2 are properly set, PGM1 will be heard with the cross fader set to the left side. PGM2 will be heard with the cross fader set to the right side. When the cross fader is set in the center, both programs will be heard. This is a detachable fader for the ease of replacement with
iPHONES JACK
Use this jack to connect the head phones. Head phones from 8 ohm to 600 ohm can be used. 150 ohm is recommended.
oMASTER LEVEL
Adjusts the signal level output from the LINE OUT jack on the rear panel.
!0MASTER BALANCE
Adjusts the signal balance of the left and right side of the outputs from the LINE OUT jack on the rear panel.
!1MONITOR LEVEL
Adjusts the head phone output level.
!2MONITOR SELECT FADER
When the monitor levels of PGM1 and PGM2 are properly set, PGM1 will be monitored in the headphone with the fader set to the left side and PGM2 will be monitored in the head phone with the fader set to the rigth side. When the fader is set in the center, both programs will be monitored in the head phone.
!3MIC LEVEL
Adjusts the input level from all microphone inputs.
5