Vestax PMC-270A owner manual Program Input Section

PROGRAM INPUT SECTION

PGM 1

INPUT

PHONO 1 LINE 2

1

LINE 1

	TRIM
2
	MIN		MAX
	BAL
3
	L		R
	EQ
	HI
	-16dB		+16dB
	MID
4
	-12dB		+12dB
	LOW
	-16dB		+16dB
5	EFFECT
	PRE	OFF	POST
6	CUE
	OFF		ON
	SIGNAL
	10
	9
	8
	7
	6
7	5
	4
	3
	2
	1

PROGRAM INPUT SECTION

1.INPUT SELECTOR

Used to select input (2 line or 1 phono) to be sent to each PGM channel.

2.TRIM CONTROL

Adjusts the Input level of each channel. Set INPUT FADER to 7-8position. adjust TRIM so that the INPUT LEVEL METER shows about 0dB.

3.BALANCE CONTROL

Adjusts the stereo balance for each PGM channel. Can be used for adjusting the unbalanced stereo image caused by a strong anti-skating setting. Clockwise rotation from center position increases the volume of R over L channel. A counter clockwise rotation increases the volume of L channel over R.

4.EQUALIZER(HI,MID,LOW)

Adjusts the HI, MID, LOW frequencies for each PGM channel. Each band has following specifications.

HI	8kHz	±12dB	Shelving type
MID	500Hz	±16dB	Peaking type
LOW	80Hz	±12dB	Shelving type

5.EFFECT SWITCH

This switch enables the signal from each programs to be sent to AUX send jack. Different signal routes can be selected this switch to different positions.

P R E : The signal before the input fader ( after the EQ ) will be sent to AUX

output.

POST : The signal after the input and cross fader will be sent to AUX output.

OFF : No signal will be sent to AUX output.

6.CUE SWITCH

Used to send the signal from each program to monitor section for headphone monitoring.

7.INPUT FADER

Used to adjust the Input level of each program. Usually set at the 7-8

position. This is a detachable fader for	Remove four screws.
the ease of replacement. Replace with
the IF-27 when it is worn out.
HOW TO REPLACE THE INPUT FADER	Remove the multi-
● Remove four screws which hold the	cable connector from
fader unit panel.	fader unit.
● Take the unit out with the panel
Carefully remove the multi-cable
connector from the fader unit.
● Insert the connector to the new fader
unit.
● Put the fader unit panel in position
and tighten the screws.

0

8.CROSS FADER

When the Input level of PGM1 and PGM2 are properly set, PGM1 will be heard with the cross fader set to the left side. PGM2 will be heard with the cross fader set to the right side. When the cross fader is set in the center, both programs will be heard. This is detachable fader for the ease of replacement with CF-R when it is worn out.

Remove the multi-cable connecter from fader unit.

Remove four screws.