Vestax PMC-07ProISP owner manual HOW to Change the Fader Unit, HOW to Remove the TOP Panel

Page 9

HOW TO CHANGE THE FADER UNIT

Note

Use a plus driver fitting screw.

Driver Knob

Caution: When you change any parts, do not

 

loose the screws with

marking.

 

Top panel

HOW TO REMOVE THE TOP PANEL

qRemove each fader knobs and 4 screws which

fix the top panel.

w Remove the top panel.

Main panel

HOW TO CHANGE THE FADER UNIT

q Remove the two screws on the fader panel.

Driver

w Remove the fader unit from position in mixer.

e Carefully remove the multi-cable connector from fader unit.

r Attach multi-cable connector to new fader unit.

t Position the fader unit carefully and secure with screws.

Insert the � multi-cable connector

HOW TO CHANGE THE Q-STICK UNIT

qRemove the three screws on the Q-stick panel. w Remove the Q-stick unit from position in mixer.

eCarefully remove the multi-cable connector from Q-stick unit.

rAttach multi-cable connector to new Q-stick unit.

tPosition the Q-stick carefully and secure with screws.

Insert the � multi-cable connector

QS - 07 ISP

8

Image 9
Contents Proffessional Quadraphonic DJ Mixer U T I O N CONGRATULATIONS!Read Before Operating Equipment Important SafeguardsA T U R E S TOP Panel Section Functions2MONITOR Select Switch PMC-07ProISP Front Panel SectionU T I O N Rear Panel SectionHOW to Change the Fader Unit HOW to Remove the TOP PanelHOW to Change the Fader Unit Connection Example Connection DiagramChain Connection Chain Connection DiagramSession Master Front OUT Front PMC-07Pro ISP Block Diagram P model Specifications Vestax Corporation