FADER CLEANING AND REPLACEMENT
After constant scratch use the
REMOVING A FADER
1.Make sure mixer is powered off and power supply is disconnected from back of mixer.
2. To remove the lower faceplate, take off all the fader knobs and then remove the 4 screws located on the side of the mixer (2 on each side). Lift up on the faceplate and it will slide off.
DESCRIPTION OF FUNCTIONS
3.Remove the fader to be cleaned or replaced by unscrewing the 2 outer screws on the fader plate (removing the 2 inner screws will detach the fader from the fader plate).
4.Disconnect the fader from mixer by removing the connector on the bottom of the fader.
REPLACING A FADER:
1.Once the fader has been removed, simply plug the connector into the new fader.
2.Place fader back in mixer and replace 2 outer screws to secure fader.
CLEANING A FOCUS FADER:
1.Once fader is removed from unit, you will need to separate the fader casing from the fader itself to have access to inner suspension. The
fader casing is the metal piece that covers 3 of the sides of the fader. To remove the casing pull apart the two flaps on the side of the fader and remove casing.
2.Once casing has been removed wipe down the rails with a
cotton swab to remove excess dirt.
3.Lubricant can be applied to the rails. Thinner
(10)Cue Level – Controls the head- phone output (23) level.
(11)Rumble Filter – Rumble is a term used to describe mechanical vibrations traveling through the turntable into the stylus and being amplified as low fre- quencies. The rumble filter will cut these frequencies off and prevent feed- back from the turntable reaching the output of the mixer. The rumble filter is adjustable from 0 Hz (OFF) to 20 Hz (The human ear can only hear above 16 Hz).
(12)Booth – Controls the level of the BOOTH (42) output.
(13)Master – Controls the overall vol- ume level of the mixer.
(14)FX1 / FX2 – These 2 buttons assign the FX Loop to its respective channel. the FX loop can be assigned to both channels at the same time.
(15)Hi, Mid, Low – Adjusts Hi, Mid, and Low frequencies (+
(16)Input Selector – Selects the input source (FX / PHONO / LINE) for each channel. When FX is selected the FX RETURN is routed to that channel and the line fader for that particular channel becomes the level control for the audio coming back from the effects proces-
sor.
(17)Aux / FX Cue – This button allows you to cue your FX RETURN or AUX input depending on the position of the AUX/FX Selector switch (37).
(18)OSII – Optical Scratch switches for each channel. This is simply an on/off switch used to perform various scratch tricks.
(19)Line Faders – Controls the chan- nel output level. The curve of the line fader is determined by curve control switch (25) located on the front panel. The line fader may also be reversed by using the line fader reverse switch (24) on the front panel.
(20)Headphone Mute Switch – Mutes headphone output (23). Mute is on when red LED is illuminated next to switch.
(21)Crossfader – Fades the overall mixer output between channel 1 and channel 2. The curve of the crossfader is determined by the CF Curve knob
(27)located on the front panel. The crossfader may also be reversed by using the CF Reverse switch (28) on the front panel.
(22)Input Level Meter – Displays each channels input (in dB) level with peak hold. When indicator shows a red bar